Mcrheist
I responded to your comments in the X-2 thread. In case you don't see it I will comment here.
First off, your dealer is a jerk because if he isn't smart he will lose you as a customer and perhaps could even jeopardize his Wilson dealership which could be yanked.
It is most unusual to blow a driver as the resistor is first in the signal path and any heavy load will blow the resistor thus sparing the driver. Have you opened the back panel to determine if it is a resistor? Have you looked to make sure that the cross over cables are firmly attached to the appropriate binding post? I have owned almost the entire Wilson line and I can tell you that it is rarely a driver which blows. If so then it can easily be replaced by a matching driver as Wilson audio keeps all of those specs on EVERY speaker that they make.
I responded to your comments in the X-2 thread. In case you don't see it I will comment here.
First off, your dealer is a jerk because if he isn't smart he will lose you as a customer and perhaps could even jeopardize his Wilson dealership which could be yanked.
It is most unusual to blow a driver as the resistor is first in the signal path and any heavy load will blow the resistor thus sparing the driver. Have you opened the back panel to determine if it is a resistor? Have you looked to make sure that the cross over cables are firmly attached to the appropriate binding post? I have owned almost the entire Wilson line and I can tell you that it is rarely a driver which blows. If so then it can easily be replaced by a matching driver as Wilson audio keeps all of those specs on EVERY speaker that they make.