2. speakers
  3. 136937-92809

Upgrade from ADS L1230

Hello, I am the lucky owner of a pair of ADS L1230.

I like the amplitude of the sound-stage and the tone is very balance with a sweet, soft and well defined mid-high.
What I am missing is definition on the low-end. I feel like the bass is not as punchy as I would like and in general I perceive some sort of sluggishness at the lowest frequencies. 

I would like to upgrade to a pair of speakers that would give me the same sound-stage and pleasant mid-high and at the same time better performance on the low-end. I was thinking about going for a used couple of speakers, having a 1500$ budget.

I am planning to driving the speakers with my actual amplifier which is a Threshold Stasis 3 with factory upgraded balanced inputs - recently fully serviced and restored (only psu caps have been updated, all the other components were within specs.)
My room is 12x18 (ceiling is 10' tall), with hardwood floor mostly covered by rugs.

Any suggestion?


marcomarmo
tomic601's avatar
tomic601
13,022 posts
 
....while I like the idea of Vandersteen 2 or even 3 , the comments about ADS are spot on - we were one of the largest ADS and Vandersteen dealers in Midwest and I am very familiar with your excellent amplifier, so my post probably should have read:

aDS known for pretty tight control bass
not perfect but....

pull crossovers and have them competently checked, while in there change caps
make sure inductors not burnt or loose on boards, check all wiring connections, make sure fill is in place
check to ensure woofers are seated against functioning seals, screws tight.
work room placement on spikes, in our Store ADS bass best out about 2’ Max from wall ( we stocked 2030 and Triamped them... )
Richard So can rebuild any of your drivers/crossovers
there is an ADS FB group also for good advice
the biamp suggestion gets you around the relatively old and designed to a price point inductors in the passive crossover
do that last...

best
marcomarmo OP
6 posts
 
Thank you for the very precious suggestions.
In the order I think I'd try to (1) decouple the speakers from the floor, (2) ensure the positioning is correct, (3) verify the state of the crossovers, (4) verify the state of the cones.

I see the ADS 1230 speakers have 5 feet at the bottom. If I mount them on spikes, how many spikes would you suggest to use? I think 3 should be the best number to ensure that they all touch the floor evenly, am I wrong on assuming this?
jackd
1,074 posts
 
If you like the ADS sound and I did back in the day but want newer in same vein look to Aerial Acoustics. I still have two pairs of ADS monitors here in storage and my son has my L810 II's I bought new. 
mickeyb
585 posts
 
Recap those bad boys. 
marcomarmo OP
6 posts
 
@jackd I hear very good reviews about the Aerial Acoustics but they are a bit over my budget. Maybe I can try to take the most out of my ADS now and save money for a pair of AA later
More to discover