Should I adjust my NAD M51 DAC volume north of 0 dB with this setup?


In the warmer months, I am running a Schitt Freya tube preamp with an NAD M22 power amp and an NAD M51 DAC. [This replaces a tube integrated in the chain with the NAD M51 from my winter system.]

My question for the technical gurus is by looking at my Schitt preamp specifications and the NAD M51 specifications, can you make a recommendation as to where I should set the volume output level on the M51? Here are the specs:

Preamp/Schitt Freya:
Tube GainGain: 5 (14dB)Frequency Response: 20Hz-20Khz, -0.2db, 3Hz-200KHz, -3dB THD: <0.01%, 20Hz-20KHz, at 2V RMS IMD: <0.01%, CCIR SNR: >95db, A-weighted, referenced to 1V RMS Output Impedance: 210 ohms Topology: differential input/output, pure triode, with low impedance followers Input Impedance: 10K ohms
Crosstalk: >75dB, 20-20kHzInputs: 2 XLR pairs plus 3 RCA pairs, selectable via front switch or remoteOutputs: 1 XLR pair plus 2 RCA pairs, selectable via front switch or remote Volume Control: relay-switched stepped attenuator with discrete thin-film resistors, 128 0.625dB steps

DAC/NAD M51:

  • Rated Distortion (THD+N with AES 17 filter)
  • <0.0005% (0dBFS)
    <0.002% (ref. 1kHz-60dBFS)
  • IMD Distortion
  • 0.0001%
  • Signal/Noise Ratio
  • <-123dB (ref. 0dBFS 2V out)
  • Channel Separation
  • >-115dB (ref. 0dBFS Volume -1dB)
  • Sample Rate
  • 32kHz to 192kHz (USB and digital S/PDIF)
  • Frequency Response
  • ±0.5dB (ref. 20Hz-96kHz @ 192kHz sample rate)
  • Output Level
  • 2V (ref. input 0dBFS)
  • Balanced 110 Ohms
Specs are available here: http://www.schiit.com/products/freya https://nadelectronics.com/product/m51-direct-digital-dac/
128x128jbhiller
I have a M51, great DAC...   I usually set mine at -1 to -3 dB going into my preamp as a source .  There is supposedly no truncation of data ubtil below -66 dB so experiment . You might find that -10 is a better match .  I personally dont think that unit sounds better as a preamp vs. a source component but it may in a different system so it doesnt hurt to try it that way as well.
I have an M51 in one of my systems and it is a great DAC IMO.

I set it at -20db or so (I do this also with another DAC in my big rig.) Both DACs claim no loss of data at that setting.

For me, it is about who provides the gain and how much. It sounds better to me to set the DAC at a lower volume and up the preamp volume to get to the desired listening level. My preamps are both CJ (ET3se and ET5) and are pretty quiet up to about 85 vol setting, which is way louder than I want even with the DACs set to -20.

I've experimented with different settings for the DACs and the pres. I've even run the DACs down to the equivalent -50 on the M51. I don't usually run the DACs down this low, given my typical listening habits...but of course I had a lot of OCD fun playing with the various knobs and dials.

I've heard recos to have the gain from the DAC at 0  and use lower volume settings on the pres...less noise I'm told. But on my system, this sounds unnecessarily thin and bright, tho' very dynamic. With the DACs dialed down and the preamps up, it sounds more coherent and organic to me with no loss (that I can tell) of clarity, bass impact, etc.

I've also tried the DACs as digital preamps without the CJs in the system. Very dynamic, but it doesn't sound as coherent and organic as with the pres in the systems.

Of course, YMMV.


I also have a c-j preamp... its a Classic 2 SE and it like most c-js has high gain. I would often leave the volume around 9 oclock on the pre and set the M51 to -20 or -10 so i could employ the remote volume on the DAC and not go past 0dB. Always sounds great . I normally hate digital volume, its why I traded my McCormack RLD 1 for the Classic, but the NAD digital volume is one of the best I’ve ever used. It is super smooth and the is no difference in quality at -20 or 0., its a great volume control. The only thing I dont like about that DAC is its lack of a front panel volume, serious omission on such a great DAC. They blew it on that one and would have sold a lot more if it was more like the preamp/dac they pitched it as .