JWC,
Higher damping and higher power are two different beasts, though the two might go hand in hand practically in many cases.
My experience with the larger OHM 5s is that they benefit from both high damping and high power and high current as well. All may often go hand in hand practically with most amps.
Damping is needed to keep dynamic drivers under control to various extents. Some drivers are more highly damped already. Walsh drivers in particular seem to loosen up over time more so than most and benefit highly from higher amplifier damping factors. The vertical mount of a Walsh driver and the increased effects of gravity accordingly might have something to do with this.
In practice, effectiveness of amp damping factors >50 or so is questionable. However, I have found with teh larger OHMs, where low end bass levels are seldom an issue, that more damping is always a good thing in terms of lower distortion and better dynamics and speed in general, ie a lean and mean bass as opposed to a fatter less refined delivery. The amps I prefer with my larger OHM 5s have 1000 damping factor. I have used other amps with 50 or less damping factor (also less power) and can hear the difference even at modest volumes.
Smaller OHM drivers benefit somewhat less from massive power and damping than larger models, but these things are still of benefit I would say, at least up to the point where a combo of high damping and smaller driver negatively affects bass levels, though I am not sure I have experienced that myself practically, even with my smaller OHM 100 driver based speakers. I would say that with the smaller drivers, cases where users prefer less damping in the amp might become more common, depending on preference, room acoustics, and other factors.
Higher damping and higher power are two different beasts, though the two might go hand in hand practically in many cases.
My experience with the larger OHM 5s is that they benefit from both high damping and high power and high current as well. All may often go hand in hand practically with most amps.
Damping is needed to keep dynamic drivers under control to various extents. Some drivers are more highly damped already. Walsh drivers in particular seem to loosen up over time more so than most and benefit highly from higher amplifier damping factors. The vertical mount of a Walsh driver and the increased effects of gravity accordingly might have something to do with this.
In practice, effectiveness of amp damping factors >50 or so is questionable. However, I have found with teh larger OHMs, where low end bass levels are seldom an issue, that more damping is always a good thing in terms of lower distortion and better dynamics and speed in general, ie a lean and mean bass as opposed to a fatter less refined delivery. The amps I prefer with my larger OHM 5s have 1000 damping factor. I have used other amps with 50 or less damping factor (also less power) and can hear the difference even at modest volumes.
Smaller OHM drivers benefit somewhat less from massive power and damping than larger models, but these things are still of benefit I would say, at least up to the point where a combo of high damping and smaller driver negatively affects bass levels, though I am not sure I have experienced that myself practically, even with my smaller OHM 100 driver based speakers. I would say that with the smaller drivers, cases where users prefer less damping in the amp might become more common, depending on preference, room acoustics, and other factors.