Nuforce STA200


I am curious about the Nuforce STA200 amplifier  If anyone has experience with the amp it would be appreciated if you would share your listening impressions, both good and bad.  Some of the descriptions I have read classify it as a class AB amp and others a class D amp.  I am not technical savvy about these things, can a single amplifier be both? 
Thanks
George
jetter
When my 160w monoblocks needed repair I ordered the Nuforce from Amazon as a stopgap.  To my amazement, at half the power it ran my very inefficient speakers wonderfully, almost equaling the sound of my original amps.
When my monoblocks went down again I thought it was time to replace them permanently, so I bought used a highly touted expensive Belles Hot Rod amp.
In short, the Belles couldn’t cut it.  It just didn’t have the power of the Nuforce which sounded much better.
I can’t  believe the quality at that price.  Amazing!

MrD, in the small room with the Proceed (Turntable room), I never listen above about 80 dB at sitting position, usually closer to 70 dB, so it never got any kind of workout, probably running at less than 1 wpc. Running my Wharfedales downstairs in an open area of around 10,000 cubic feet, I had it running at a moderate level (my wife would say loud) filling the entire area for hours and it was lukewarm at best afterwards....

Just weird, never had an amp act that way.
Check pictures of the Job 225 and STA200 again. They use the same circuit board with different caps, resistors, etc. The power transformers and RCA jacks are also different.
I guess adding to the above, and I have not looked into it at all, I get the impression that the STA200 is the only non class D amp they make?