Duelund DCA16GA

@grannyring ... I`m using a 300 Watt per Chanel SS amp.
My speakers are Revel F52`s the published specs show an efficiency rating of 87.5 db
6.5 Ohm nominal 3.5 Min @ 373hz
I was using a 6Ft length of cable run using the Duelund.
The MIT`s are  8 Ft .

My buddy has Zu Audio speakers with a 100 watt Rogue amp we`re going to try them just to see.  

I see. Thanks for the update.  

Does the tin coating on this wire melt away during soldering when making ICs?

For those of you who use bare ends for speaker cable, are you removing the tin coating with something like Scotch-Brite? It doesn’t seem like a very good idea for the signal to have to pass through the tin coating.

I’m debating making a set of speaker cables for my Magnepan 3.6Rs that are bi-wireable. How many runs and what configuration would work? The amplifier is a Classe CA-200 and the they will be 7 to 8 feet long. Would non-biwiring work better?

The tin coating helps give it the wonderful sound.  It is part of the design and a big positive. No, it does not melt off and cannot be removed. I know the notion of tin costing and suburb Sonics can seem at odds. But it could not be further from the case with this Duelund wire. 

In this wire it is your friend ✌️