Tekton Double Impacts

David_ten
Are you going to purchase the Perfect from Tekton? I'd like to know your results if you do purchase. I'm seriously thinking about testing them out myself. I currently use DeVore 0/96 in main system, that is what Perfect will be up against. I'm sort of waiting for teajay upcoming review. How to compare/contrast with his review of NSMT. As you might know I’ve owned three pairs of Tekton's older speakers, Lore, Mini Lore, and an early small single driver. All performed great. Best, mikirob

@mikirob   I'm considering the Perfect SET speaker to pair with my 2A3 / 8Ohm amp. I also have other speakers that are high or higher on my list.

The 2A3 pairing with the Tekton SEs has so far exceeded expectations, that it is (most unexpectedly) complicating my speaker choice.

If I move forward with the Perfect SET, it will likely be with custom drivers, which Eric will install. In other words, this will not be a DIY effort.

I believe Mike Kay of Audio Archon is receiving a stock Perfect SET pair soon. You may want to reach out to him, as well.

@david_ten 

Hey David, I was just wondering where you were at in your speaker search.  

So, what are your priorities in the sound you are after and what are you willing to give up?  (there's always a compromise, right?)  It seems Eric can work some magic with less than sophisticated drivers.  (Not that measurements tell the whole story, but have you ever seen a flatter FR curve than that of DI monitor is Stereophile??)  I am not of the opinion that top drawer drivers guarantee much.  You can have a great filet mignon in the fridge but it only becomes special in the kitchen.  I mentioned once that a speaker I built using then top of the line drivers (scanspeak revelator/aircirc tweeters) was only good.  I actually derived more enjoyment out of some vifa drivers using a series crossover.  The Vifa build has some magic in that simple crossover and the end result was quite beguiling. 

So I would of course get Erics input on the virtues of the drivers he has worked with.  I would also wonder on putting more money into the crossover and cabinet damping as well.  The crossover could be a more cost effective avenue to look at, especially given the fact it's part count has to be lower than that of the DI's that Bill took on.

Keep us posted on what you find out!

@corelli  Fantastic advice. And so very true! Thank you.

Eric is very open to customizing the Perfect SET. When I spoke with him he was working on a Perfect SET with a 15 inch bass driver for a client. 

The Perfect SET is also setup to accommodate the BE tweeters that he uses in the BE Ulfberth. 

I will be following his lead, but figured it was worth asking since some of you have changed out drivers, etc. on various Tekton models.

I am open to tweaking the crossovers, wiring, etc., should Eric agree to and endorse those changes. 

I was just wondering where you were at in your speaker search. So, what are your priorities in the sound you are after and what are you willing to give up? (there’s always a compromise, right?)

@corelli Great questions.

I’ve been ’wandering’ in the search. Lately, it has felt more like ’flailing’ : )

Top choices are the Cube Audio Nenuphar, Voxativ, and Horning Eufrodite Ellipse (and a few others).

The primary goal is for a synergistic pairing with Scott Sheaffer’s Found Music 2A3 amp. I now have the Grandinote Genesi solid state Preamp ahead of it and I am moving towards a full analog signal cable loom from Scott Sheaffer (his silver 2112 ICs and E+ SC).

At this point, with the T+A PA 3100 HV / SR cabling based system and the system described above, sound quality is superlative.

Therefore "priorities in sound" are mainly focused on increasing naturalness, realism, and my emotional connection.

I expect gains to be slight, but am hopeful for a shift in Gestalt and a ’higher level’ whole, when all the elements come together.

The other top priority is to learn about and experience different speaker design and approaches.