Sound quality vs. volume


Looking for a bit of expertise here:

I recently made a few changes to my setup and while overall pleased with the results, I’m on the quest for better.  I’m hoping you all can help me diagnose an issue I’m hearing.

When listening to music at lower volume levels - say less than 1/2 total volume, the clarity, imaging and dynamics come across far more coherent and “in focus”.  To use an often over-coined phrase “It’s like I’m there in the room”.  As I start to push the volume up a bit, closer to live-performance levels, the sound becomes increasingly “mushy”.  I know, a highly technical term, but the best way to describe what I am hearing.  The bottom-end loosens up - getting a bit boomy, the crispness of the mid-range and highs fade and the imaging falls out of focus.  These are all incremental with volume until I get to the point where it’s just unbearable.   

I’m no expert by any means but feel it might be room acoustics.  I already know I have a less than ideal setup with a nearly square room (21x20ft) with 60% of the surface covered with clear birch wood paneling. Some things we can’t change (easily).  I do not have any acoustic treatment, just lots of soft furniture.  What I find interesting is that my old setup (Magnepan 1.6) didn’t suffer to such a degree.  Maybe with the new setup there is more to loose?  A mystery.  

For a bit more context:  
Speakers:  Dynaudio Contour 60
Streamer: SoTM sms-200 Ultra
Amplifier: Peachtree Nova500

Within the 20x21ft. room, my speakers are 4ft. from the wall, I am seated 13ft. from the front wall (a bit back from room center). Speakers are 9ft. apart.

Any thoughts?  


wanderingmoo
Great wanderingmoo, I'd love an explanation for that username. Anyway, those speakers are quite capable of a clean 110 dB with the right amp in your room. Subs will increase your headroom and lower distortion in the mid bass but do not bother until you can afford two. One sub can be very frustrating for listeners who cherish accuracy. This is what gives Subs a bad rep in some circles. As for your room acoustics because of the dimensions you are going to produce standing waves around 40 Hz. As you walk down the room the bass will go from too loud to almost non existent then back again. We use to deal with this by placing the listening position where the bass was right. Now we have room control. You could also bulldoze your rear wall down;)  For upper frequencies, to improve your imaging and smooth out your frequency response you want to dampen the four strongest primary reflections (PR) in your room. Basically you are playing pool with your room. if you roll a ball from the listening position to the side wall you want to hit the point at which the ball will rebound into your speaker. That point is one PR. The arrival angle of the ball from a line perpendicular to the wall will equal the departure angle from the same perpendicular. Look at the geometry on paper. You want to find 4 PRs one on each side wall and two on the front wall between the speakers. Once you locate the PRs make  3 X 3 or 4 X 4 foot panels at each one at ear level using 12" acoustic foam tiles. partsexpress.com. They are dirt cheap. I tack them up with double sided tape. 
Glupson, actually our ears will tolerate 100 dB just fine as long as you get there correctly. Start off at 85 dB and go up in 5 dB increments every five minutes. This gives your stapedius muscles time to clamp down on the occicles, the three little bones that attach the tympanic membrane (ear drum) to the oval window of the cochlea (microphone). Impulse noise like a gunshot at 100 dB is far more damaging. No time for the stapedius to damp down the volume. Always warm up your guests accordingly.
@wanderingmoo. In my opinion the compression that happens at higher volumes is related to electronics and room . I can listen at 105 dB in my listening chair after changing electronics ( monoblocks, preamp, dac) from parasound to ayre and cables from kimber select to cardas clear without compression. Speakers and room acoustics are the same . The sound opened up at louder volumes . The performances sound real and there . 
Room acoustics and smearing I had talked to acoustic sound company , they sent me an audio file via email and we did the “Matt test” to identify reverb and echo in my room in my listening chair . They then made their specific recommendations. Nothing random, nothing textbook . But based on data collected from my room. You can contact them and they can help you. They work with the decor of the room and waf also 😊. Good luck . 
Let me say this about that.

Once anyone gets a very satisfying balanced system and speaker/room setup, most often you will find you very rarely listen as loudly as you used to. You are busy being immersed, involved, hearing things previously undiscovered.

Once a level of involvement is achieved, it is time to move to superior content, broaden your interests/experiences, move into phono if not there, move into Reel to Reel if not there, ... all of which enrich the experience far beyond tweaks.
It's the amp that causes 'mushiness' at higher volume levels. Upgrade your amp.Some big/heavy "high current" mono blocks.