Herron VTPH-2A Phono Preamp....anyone familiar?


Hi just reaching out to get any input/feedback  on the Herron VTPH-2A Phono Preamp.   While I'm happy with my existing Parasound JC3 Jr., someone recommended the Herron, so I got intrigued, as I've never run into, nor listened to, any Herron products.  
Thks, Jim

jhajeski
Chakster

I do not call 2 years " gave up so quickly"

You may not recall but at that time I was convinced I wanted a Herron or a Chinook back then but thanks to sensible advice right here it was decided that certainly the Herron would not be a good match impedance wise for my then present Lyngdorf 2170.

If the Gold Note was the be all and end all of phono stages then everybody would have one and there would be no need or market for anything different/better.

Sometimes it is indeed a case of the grass is greener but in this case with so much overwhelming support for the Herron ( and the Chinook) I do not believe it is just smoke and mirrors.

The only weak point of the Gold Note in my system is the bass.


And there we have it.... " in my system".

One cannot expect everybody to get the same results as in your system Chakster.

You have some good advice to offer at times on certain subjects but also it appears that when someones decision does not align with yours then they must just be wrong.
@uberwaltz It is not about right or wrong and i am not advocate of Gold Note here, in fact you guys promoted it for 2 years. I feel the lack of bass with this phono stage, sadly.  

Just curious how many phono stages we have to buy. 

I bought two, but my first one still better in low registed than all of the new phono stages i bought (including gold note) pretending for upgrade. Comparison is the key. 

After reading audiogon for years i see most people are from the USA and they are always vote for Made in USA products when it comes to the phono stages. 

I'm looking forward to read your comments about Gold Note vs. Herron 

Chakster.

I have not actually made the decision to purchase the Herron yet, hence digging up this thread and asking further questions.

Still using the Gold Note right now and possible the lower bass is a little lacking but not terribly so in my system.

However tubes were and have always been on my radar.

Just as an example, I purchased a very simple iFi audio tube buffer which I placed inline between my Nak tape deck and Ayre and it really fleshed out the bones a fair bit. Now sounds flat without it inline.

Still chewing it over.
Uber, If you can, listen to a Manley Chinook.  I haven't heard the Herron, so can't say how it compares, but I'm very happy with mine.  
I urge you guys to read an elementary book on audio electronics. You might thereby learn to understand why a preamp (for one example) exhibits disappointing bass response compared to another. In this case, it might simply be a matter of the value of the output coupling capacitor. If so, the problem can be fixed by installing a different capacitor of higher value. Also one needs to pay attention to the input impedance of the device that the preamplifier is driving. These factors can make all the difference in the world, And they can be fixed without spending thousands of dollars on an entirely new device.