Herron VTPH-2A Phono Preamp....anyone familiar?

@uberwaltz It is not about right or wrong and i am not advocate of Gold Note here, in fact you guys promoted it for 2 years. I feel the lack of bass with this phono stage, sadly.  

Just curious how many phono stages we have to buy. 

I bought two, but my first one still better in low registed than all of the new phono stages i bought (including gold note) pretending for upgrade. Comparison is the key. 

After reading audiogon for years i see most people are from the USA and they are always vote for Made in USA products when it comes to the phono stages. 

I'm looking forward to read your comments about Gold Note vs. Herron 

Chakster.

I have not actually made the decision to purchase the Herron yet, hence digging up this thread and asking further questions.

Still using the Gold Note right now and possible the lower bass is a little lacking but not terribly so in my system.

However tubes were and have always been on my radar.

Just as an example, I purchased a very simple iFi audio tube buffer which I placed inline between my Nak tape deck and Ayre and it really fleshed out the bones a fair bit. Now sounds flat without it inline.

Still chewing it over.

Uber, If you can, listen to a Manley Chinook.  I haven't heard the Herron, so can't say how it compares, but I'm very happy with mine.  

I urge you guys to read an elementary book on audio electronics. You might thereby learn to understand why a preamp (for one example) exhibits disappointing bass response compared to another. In this case, it might simply be a matter of the value of the output coupling capacitor. If so, the problem can be fixed by installing a different capacitor of higher value. Also one needs to pay attention to the input impedance of the device that the preamplifier is driving. These factors can make all the difference in the world, And they can be fixed without spending thousands of dollars on an entirely new device.

Lewm

In regards to input impedance I most certainly did pay attention which is how I ended up with the Gold Note to begin with as the Herron was NOT going to play nicely with my then present Lyngdorf 2170.

However with present Ayre EX8 with input impedance of 1m ohm/ 2m ohm unbalanced/balanced the Herron should be a sweet matchup.
As should the Chinook and likely countless others.

Not looked into the output coupling capacitor but that would mean changing parts internal which I do not have a huge issue with apart from it potentially hurts future resale value?