Ears hurt when listening after changing speakers


For years I had multiple models of Maggies and Martin Logan speakers. I could play them very loud with no problems with my ears. A few months ago I purchased the Rockport Aviors and now when I listen at moderate to high levels my ears start to hurt.  Anyone one else experience this when changing speakers and would like thoughts on how to resolve other than turning the volume down.  I do love the Rockport.
128x128lourdes
I'm wondering if the problem may be caused by ultrasonic frequencies the Avior is able to reproduce but the other speakers were not able to reproduce.  The Avior's frequency response is spec'd at 25 Hz to 30 kHz (-3 db), and Stereophile measured the similarly spec'd Avior 2 as actually having a small peak at 30 kHz, that being the highest frequency for which they measured frequency response.

What electronics are you using?  Perhaps the amp is not happy with the low impedance of the speaker at ultrasonic frequencies.  For the Avior 2 Stereophile measured an impedance of about 3 ohms between 20 kHz and 30 kHz, and about 3.5 ohms at 50 kHz, although impedance phase angles were benign in those regions.

Regards,
-- Al

I would observe in general switching from planar or electrostat speakers like Magnepan and ML (very easy on the ear) to large dynamic speakers like Rockport alone is a big difference that one’s ear’s may not be used to and find somewhat fatiguing...definitely much different which may be good or bad depending on the listener.

Not uncommon that a major change in speakers causes a ripple effect leading to changes with gear back upstream to get things right again.

It could be that other tweaks/changes might be needed to get a more relaxed sound out of the new combo. Tone controls might be handy.

Are the tweeters pointing directly at your listening position? If so changing that might help.

If grills are off try putting them on.

Like mentioned above, it could be that the new dynamics are not for your ears in which case either listen at lower volume or maybe consider adding a dynamic range processing device to allow you to go louder without hitting uncomfortable peaks. dbx devices used to accomplish this, there are probably good quality digital processors available today that can do it much better.

Power conditioning might help and would be worth a try if not in place currently I would say.

Are your wires shielded? That is a good safeguard to avoid possibly picking up noise that adds to fatigue.

Just some ideas....

Also possible your ears will just adjust.... give it some time before doing anything drastic.














Are the Rockports new? You love the Rockports but they hurt your ears?
reduction in spl vs seating distance is almost perfectly linear with panel speakers and is almost exponential with point source speakers. Dispersion in the room is also different.

What I’m talking about is the idea of setting listening levels with a standard volume pot while standing and then moving to the listening position, vs adjusting while in the listening seat.

The experience of changes in sound levels while moving around the room is notably different in the two driver technology types.
Are you talking about listener fatigue (can't/don't want to listen for very long) or actual physical pain?