2. speakers
  3. 150342-122106

Searching for matching(?) Subwoofer solution

Hi folks,

I have a relatively new setup in my home office (12' x 14' with hardwood floor) and am seeking recommendations for a subwoofer solution.

Speakers: Ologe 5
Preamp:    Bryston P26 
Amp:         Forte 1A
Budget:     Flexible but just want something to provide a good match for the above components.
Music:       Mostly Classical and Jazz.  Some rock, some fusion.
Source:     Well, that's something else I am seeking advice on too and will post under the appropriate discussion topic

Problem is none of the local Hi Fi shops here in the Boston area have any experience with, let alone heard of Ologe speakers.  Couldn't get any recommendations there.

Has anyone owned or at least listened to these speakers? Or any of the other Ologe speakers?
The Ologe site (http://www.ologe-acoustic.com/) features a subwoofer called Ologe 20 at USD $8550.  
Just wanted to look into alternatives before dropping over 8 grand on the Ologe 20.
 I am open to but don't know much about subwoofer swarms.

I am not looking for anything overkill.  Just a subwoofer solution to nicely complement my somewhat modest home office system.

Thanks,
H
hleeid
hleeid OP
219 posts
 
Ok, hearing about Duke arranging each main speaker with a sub solves the majority of my small room size issues. 

Does it matter if the woofer is layed down horizontally on the floor?
If not, a horizontally situated woofer would fit under my floor stand supprted Ologe 5 speakers. 

Leaning towards the DEBRA system since the (flatter?) profile woofers would probably take up less floor space.

Unless,... 

Duke - are you building (or have built) a new sub array system for smaller rooms?

Thanks,
Hans
audiokinesis
2,749 posts
 
"It seems like your new system concept will probably work well not only in a variety of small rooms, but also some medium sized rooms."

The main speaker array has a lot more dynamic range than one is likely to use in a small room, so yeah the system should work well in a medium-sized room too. Virtually everything in speaker design being a juggling of tradeoffs, I did make a few in favor of small room optimization.

"Does it matter if the woofer is layed down horizontally on the floor?"  

Nope! I have several customers who use at least one Swarm unit on its side, sometimes on the floor, sometimes atop a book case.

"Leaning towards the DEBRA system since the (flatter?) profile woofers would probably take up less floor space."

Sounds good to me! (For the record, I don’t get a "kickback" on Debra sales.)

"Duke - are you building (or have built) a new sub array system for smaller rooms?"

Not yet, but shoot me a message or an e-mail if you’d like to exchange ramblings about tradeoffs.

Duke
mijostyn's avatar
mijostyn
8,570 posts
 
Duke, I think what people are concerned with is the size of the subs in a small room. I'm sure you know all this already but using a smaller enclosure with the appropriate driver then digitally equalizing it may suit people with smaller rooms....as long as you have the power to do it. It is just like treating the room as a Honda Hatch Back:) Might be a good product for you.
audiokinesis
2,749 posts
 
"Duke, I think what people are concerned with is the size of the subs in a small room." 

That makes sense, but I don’t think I can offer a practical solution.

You see, in part because I’m a small company, my costs don’t scale down proportionate with enclosure size. So as I start shrinking the boxes I start to become less competitive with four small off-the-shelf subs.

Duke
clio09
3,360 posts
 
I've been using 4 small enclosures with 8" drivers in my room for a while. The low pass is EQed to 30 Hz, but not digitally. The concept came from the old Beveridge 2SW and it's RM-3 active crossover. Today I just built the first of 4 boxes with a 10" woofer where the low pass will be EQed to 24 Hz. The external dimensions of the enclosure are 14 x 14 x 7.5 (internally .542 cu. ft.). So not such a big footprint. I currently use a method of placement for the subs recommended mijostyn as he and I have Acoustats and this method works quite well with these speakers. I have used the distributed array placement as well. IMO both methods are very useful.
More to discover