Speaker cables for OHM Walsh 5 MKII?

They sound good with most any speaker wire if everything else is in order. I would not go too hogwild spending money on expensive speaker cables.

I do have a pair of Audioquest cv-6 with the DBS devices in use with my 100S3s. This combo sounds very good. My 5s are in another room conencted via in wall wires that are essentially 12 gauge or so typical copper strands, nothing fancy, commercial grade in-wall speaker wiring. I am hard pressed to associate any better sound with the audioquests because the setups and rooms are so different, but I will say the Audioquests probably leave little to be desired, although I still cannot determine if teh DBS devices actually affect the sound.

FWIW, I am using entry-level Kimber Kable on my Walsh 2000s. They sound good to me, but I haven't compared them to anything else. I do intend to at least try higher-end cables at some point, however.

Thanks for the replies guy's! Any recommendations on setup
as I find no real answers anywhere. I know it's all room dependent, but wonder if there are any do's or dont's with these as starters. I have them sounding really good, so I
must be close!

For starters, at least a foot or two from rear wall and at least a foot or so from sides, with speakers generally farther apart than distance from listening position, but this can vary. Make sure tweeters are pointing forward towards the center of the room, in general crossing in front of prime listening position.

For 5s with adjustments, I recommend starting off towards lower settings for room size and bass/position relative to walls, then tweak from there as needed to get the best blend of soundstage and imaging and bass levels. Moving out from rear walls in general will improve imaging but will also affect bass levels. Small differences in actual location can make a big difference. Experiment until tuned in optimally.

Thanks Mapman! I seem to be off in the right direction
as that is pretty much the way I'm doing it.

I have them 2'6" from wall to back of "can" and they are
8'7" center to center, and I am 11' back. Settings are
(and seem to be best) at 0,0,-,0.

Maybe I will try spreading them out a bit further, but
think I am loosing the center fill & imaging if I do that.

I wonder if John at OHM makes a bottom plinth or what ever
to replace these wheels on the Walsh 5's. Makes moving them
in small increments hard on thick carpet!

Thanks again for your suggestions!