Dunlavy SCIV - What amp are you using?


I noticed lately a lot of talk about Dunlavy Speakers. I was wondering what your favorite amplier of choice is with the SCIV or SCIVa?

I've been using a Bel Canto SET40 stereo amplifier that uses 845 Triode Transmitting tubes in single ended mode that puts out 35watts rms and gives 75 watts peak. It is very extended at the extremes and has a breathtaking midrange to die for.

I'd love to hear what others have been using.

Thank you.
no_regrets
No_regrets, you make a VERY important point concerning room matching.

As I've mentioned before, I owned a pair of Duntech Princess (older sibling to the SC-IV and IVa) for 19 years. During that time I heard the Sovereigns maybe half a dozen times, at the CES, at dealers, and in private residences. I always preferred the overall presentation of the Princess because it seemed the Sovereigns required a larger space. Several factors are at play here.

First is the appropriate listening distance to allow the drivers to integrate. The manual for my Princess stated that all measurements were taken at 3.5 meters. That told me John Dunlavy believed this was the minimal distance for full integration. The DAL SC-V and VI and the Duntech Sovereign are all taller so may require even greater distances to optimize.

Second is the distance out from the front wall. After measuring for smoothest bass response I ended up out roughly four feet. I suspect the Sovereign and SC-V and VI require more distance because of their additional bass drivers.

Third is the distance from sidewalls. My room configuration only allowed about two feet from the wall for the right channel (much more for the left). I had four friends who owned Princesses and they all had greater sidewall distances. Their soundstage and imaging were all better than mine. I've always believed this is why Dunlavy often recommended long wall placement - to allow greater distance from sidewalls, thus providing longer delays in sidewall reflections and therefore better resolution.

Now there will always be someone who says, "my SC-IVs are in my den/bedroom/other limited space and they sound great". I would not say they don't. But I believe they would be BETTER in a larger room.

So whenever someone considers Duntech or DAL speakers, cost will not be the only factor, appropriate speaker to room size should be accounted for as well.
I used Pass Aleph 2 mono with the SC IVa. It was a very good match. I heard that Dunlavy had those amps in house and that they liked the match.

Interesting to see the number of people using tubes, but maybe not as I recall the IVa to be a "easy" load even if it is lowish for tubes at a nominal 4 ohms.

My HT center channel uses an ARC VS 55 driving a Dunlavy SM1 in a vertical biamp setup - works great.

TD
i have SCIV's and bi-amp them. bought the Dunlavy's new in 1995. have EAR 509 monoblocks for mids and treble, a Carver Sunfire amp for woofers. it sounds great. they are very easy to drive, very stable load, 91db efficiency.....
With all of you Dunlavy owners congregating in this thread, can I ask if any of you have put your speakers up on something -- cones or whatever? Any good?
Drubin- I stuck my SC-IV Improved on some home made spike/sands. Basically just some 16" wide cherry stock with 2 3/8" spikes drilled in and leveled. The strips sit just inside the base dimensions and elevate the speakers about 1 7/8". My floor is carpet over sprung wood with a basement under the room so in MY ROOM ( note emphasis to avoid possible flame jobs ) I found the bass to become faster, more well blended and in my opinion, better. The second benefit to me was the raising of the tweeters. My couch is a bit taller than average so the elevation helped the 'stage and image depth.
I have considered going with some Mapleshade brass footers or even some older Audiopoints but the cost just seems tough to justify. I have about $12.00 in my home brews and the cheapest I have seen the right size cones go for is in the area of $150.00.
Just to keep on thread topic, i am running my speakers with and Ayre v3 w/ K revision and Ayre Condtioner.