Also, I confirmed before purchasing the second amp from Luxman that they could be run in mono configuration using the above setup so I am confident it is setup properly.
What does an impedance-matching issue "sound" like?
I recently added a 2nd Luxman MQ-88uSE to my 2 channel system, bridged to mono so I am running a Luxman to each of my 6ohm Volti Rivals.
The SE version of this Luxman amp only has single speaker taps which output 25Wpc to 6 ohms, and 20Wpc to 4 ohms and 8 ohms (from the manual). I used a jumper between each of the "positive" taps so I am not sure what the bridged output is to the 6 ohm Rivals.
Now what I am hearing is definitely more power and presence in the sound, better bass, as well as improved separation. BUT occasionally I am hearing what sounds like a bit of breakup deep in the mix of some songs. Like the whole channel isn’t breaking up, but suddenly a rhythm guitar part sounds noisy like it’s being played through an AM radio or something. On some songs, the entire mix may sound reduced in scale and less dynamic.
I am not sure if my ears are playing tricks on me, or if I’m crazy, or if there could be something happening in the pairing of these amps and speakers that is bad for the equipment and sound. I realize this is a complicated issue because one amp is brand new and the other is broken in, and they are both tube amps., So chasing down the culprit could get messy.
Is it possible there are impedance issues at play here? What would that sound like?
The SE version of this Luxman amp only has single speaker taps which output 25Wpc to 6 ohms, and 20Wpc to 4 ohms and 8 ohms (from the manual). I used a jumper between each of the "positive" taps so I am not sure what the bridged output is to the 6 ohm Rivals.
Now what I am hearing is definitely more power and presence in the sound, better bass, as well as improved separation. BUT occasionally I am hearing what sounds like a bit of breakup deep in the mix of some songs. Like the whole channel isn’t breaking up, but suddenly a rhythm guitar part sounds noisy like it’s being played through an AM radio or something. On some songs, the entire mix may sound reduced in scale and less dynamic.
I am not sure if my ears are playing tricks on me, or if I’m crazy, or if there could be something happening in the pairing of these amps and speakers that is bad for the equipment and sound. I realize this is a complicated issue because one amp is brand new and the other is broken in, and they are both tube amps., So chasing down the culprit could get messy.
Is it possible there are impedance issues at play here? What would that sound like?
- ...
- 38 posts total
- 38 posts total