Anyone try stuffing their ports?

I have always been suspicious of port stuffing as a technically valid solution. If a speaker was designed to operate with a port, how can it be correct to plug the port, thereby making it a virtually sealed box?

There is still some energy transfer even with the port being filled (not sealed). It has more to do with the room than the speaker.

I think ports are used strictly to achieve lower freqs. instead of increasing the size of the box. That said, assuming correct, does stuffing the ports change any other characteristics of the sound other than just low freq. output? For example, if the drivers being ported are also intended for mid freqs., would mid freq sound be affected as well in any way?

"f a speaker was designed to operate with a port, how can it be correct to plug the port, thereby making it a virtually sealed box? "

Plugging the port is an extreme case.

The effective approach is to restrict the air flow through the port to various degrees in order to reduce the energy level at the low frequencies the port is designed to enhance to various degrees as well, more or less like a specialized type of bass tone control.

Good speakers are designed to perform well in a variety of rooms however the room acoustics largely determine the results regarding the bass region to which ports are directed. Obstructing the port to some degree (as opposed to blocking it which is the extreme case) can be looked at as a way to fine tune the design of the speaker to best match the room. This does not defeat the design in any way if done right, it merely adapts it better to the room and teh listeners location within it. Its another (easy and practical) thing that can be done to better match the speaker to the listener's environment, along with tweaking speaker location and toe-in, room treatments, etc.

I would say it is ill advised for anybody to be spending money on upgrading equipment until they have done everything they can first to optimize the sound of what they have in the listener's environment. That is the key to good sound in most cases. Obstructing the port to various degrees is just one weapon in your arsenal if your speakers are ported.

Rather than follow some dogma about what is the right and wrong way to approach audiophile sound, try tweaks like this that are easy and cheap to implement and painlessly reversible as well if needed and let your own ears be the judge, which is all that matters.

The benefit of the bundled straw approach is that you can adjust its affect by adjusting which straws extend in or out in comparison to the other straws. I would bundle the straws and then tape or secure them together as a single bunch (around the perimiter), leaving all the straws (except the outer layer) free to be adjusted. I would start with them all the same length, but then you can adjust a certain percentage either in or out farther to adjust the results of their use. I would definately recommend trying this approach, it is virtually free (as is port stuffing in general). The speakers I own (Gemme Katana's) come with a port insert (that reduces the overall size of the port) and when installed delivers tighter bass vs. a more boomy bass without them installed (in my room at least). Using the straw bundle approach should produce two affects; 1 - reducing the overall size of the port and 2 - providing for some tuning of the port.