DIY speaker isolation base for a wood floor

Thanks Geoff! I had a video of me pushing on it but couldn't download it here.  What are the dimensions and wire diameter that You sell? You are a great resource

So Geoff, do you recommend me doing away with my neoprene/cork sandwich and use my two 16x16 granite slabs?

Pushing up and down on the springs when they’re set up is a good way to measure the resonant frequency Fr of the system. With a stop watch count the number of complete up and down cycles and divide the total by 10. If properly set up you should be able to get down to 2-3 Hz (cycles per second).

I like granite slabs a lot because they are very stiff against bending forces. But I eschew rubbery things in the context of isolation. I suggest very hard cones for mounting and stay away from Sorbothane, cork, rubber, etc. as soft Springy materials store or block energy and interfere with the actual springiness of the springs. Energy should be allowed to exit the system as rapidly as possible. 

audiozenology "Wood floor. Assume somewhat springy? ... then usually better to isolate"

Before isolation I would try to load with mass first it is much more likely to work in that type of situation when using a Music Reproduction System speaker.

Blueranger,


Just using springs will be wobbly. If you are targeting 2-3hz resonant on the springs, then most higher frequencies will not be transmitted .. it flops.  If you add dampening in parallel with the spring (ie sorbothane), then you can keep a low resonant frequency, but damp oscillation. Some higher frequencies will now pass (still highly attenuated), but the system will not feel nearly as "floppy" as the resonances are damped.


Wrt Clearthink's post on just adding mass, all that does is change the resonant frequency of the speaker/mass and spring (i.e. your floor). The spring constant, i.e. your floor does not change. As I mentioned above, a wider stiff base (ie your granite bases) does change your floor interface which may transfer weight closer to the joists which will change your spring constant (floor).


Where Geoff and I agree is on a spring loaded floor isolation is better. I prefer damped as that damps out cabinet vibration and isolates from the floor.