Frustrated with Vinly

For a different solution try this: https://newatlas.com/sweetvinyl-sugarcube-sc1-click-pop-removal/55832/

I agree with Johnread57 above. I have hear the sugar cube unit in operation and it works great. It is a little pricey but not a budget buster.

Ability to NOT HEAR normal amount of Static is Acquired, allows involvement without disruption. Ticks and pops are disruptive to enjoyment.

Played LP's from 1960 until CD players cost became reasonable. Teenager, cheap equipment, no care of lps.

Played CD's, Holy Crap, no noise, for life, Nirvana.

Inherited Thorens Heavy Platter TD124 with SME 3009 arm, bought Shure V15V.

Tried Vinyl again. Noisy.

Had to re-acquire the brain's ability to listen to the music and the brain to ignore static. Once acquired, realized, CD was a trick, Analog is the real deal.

Realized, many of my old LP's were beat up, so began acquiring new or very good used.

Cleaned on the TT Platter, with squirt and brush and wait to dry. Waiting to dry disruptive to enjoyment.

Just upgraded to Dual Arm TT, superb heavy plinth, better arms, new cartridges.

Better equipment does a better job of revealing problems, i.e. my dirty records.

Bought one of these, (like chackster recommended)

https://www.amazon.com/gp/product/B07GSSQ1MN/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1

the primary advantage for me is the drying rack, clean 10 at a time, play them later or tomorrow. (chacksters has the drying rack also, it is just not shown, it stores inside the base.
..........................
repeat, IF New LP's are too noisy, it's more likely cartridge alignment/stylus condition, New LP should need a simple swish with dust/static brush, and sound great.

I also always hated a dirty stylist.  They get too much grease in your hair.

I t was mentioned that M/C cartridges might mask tics and pops. Could this be from a heavier traking force.  I am going to play with thjis idea by adjusting mine.