2. amps-preamps
  3. 156948-380

2 amplifiers connected to 1 set of speakers

I’ve been in the hobby for a few years and my wife asked me a question that stumped me.

Can you have 2 amplifiers, connected via their own individual sets of speaker cables, connected to the same pair of speakers at the same time? I told her I didn’t think that would be advisable.

The question came about when she saw me disconnecting cables from my solid state amp and connecting the cables from my tube amp. (both were off of course). She asked me why it wouldn’t be ok and I started babbling that the signal from one amp would then travel through the other set of connected cables into the amp that was not in use. Even if the other amp was off that could be problematic. If the other amp happened to be on then it could prove catastrophic for both amps and potentially cause an electrical fire.

What is the correct answer fellow audiogon members? Ralph?
ghasley
oldhvymec
5,101 posts
 
POP a fuse if your lucky, if not it's all down hill from there, from a pop to a BOOM, get my drift? 
There is a way to combine amps if they are made for it, "strapping" or "bridging". You bridge the amps, then run a single set of speaker cables if you have a single set of speaker binding post. A lot of pro/car audio stuff is that way.  Mcintosh, too, they can be strapped and stacked..
Grateful Dead, used 2300 or 2500, maybe both.

You want an A/B switch... be careful.. Don't switch live.  It will be in the signal path. Something to think about.. A cheap switch box, maybe not a great idea for quality sound...

A good passive preamp.. good traces, good wire, good switches.. 100.00 and you can fiddle a bit. Still in the path though...

Regards
millercarbon's avatar
millercarbon
12,531 posts
 
She asked me why it wouldn’t be ok and I started babbling that the signal from one amp would then travel through the other set of connected cables into the amp that was not in use. Even if the other amp was off that could be problematic. If the other amp happened to be on then it could prove catastrophic for both amps and potentially cause an electrical fire.

What is the correct answer fellow audiogon members? Ralph?

The correct answer to your wife’s question is of course:

"Good question, honey. Now all I need is a new set of cables...!"

imhififan's avatar
imhififan
2,205 posts
 

Most (not all) SS amplifier has relay at the output for delay turn-on and protection. If both tube amp and SS amp are connected to the speaker and only the tube amp is on, it will do no harm to both amp because the SS amp output stage is disconnected by its built-in relay.
When the SS amp is on and the tube amp is off, then the SS amp will see the speaker as a load and also the tube amp output transformer secondary winding parallel to it. That will be bad for both amplifiers, there’s possibility fries the tube amp OPT and damage the SS amp or put it into protection mode.
Even though if the tube amp OPT secondary winding strong enough to stand the current from the SS amp, the speaker will definitely sounded weak with no bass because the inductance of the OPT secondary winding drained all bass energy through it.
millercarbon's avatar
millercarbon
12,531 posts
 
Good answer. Impressive, even.

I would however want to be ready with the follow-up, "But what if they're both on?"  


b_limo's avatar
b_limo
2,277 posts
 
https://systems.audiogon.com/systems/8685
More to discover