2. speakers
  3. 158131-148047

Infinity RS 2.5 Speakers Description - Need help connecting wires properly on woofers

I had the woofers refoamed and I can’t find the paper I marked down on where wires were before I disconnected them for repair!
There are 2 pairs of terminal tabs, one that is blank and one marked 2 ohms.
1 set of wires is solid red and black/red
1 set of wires is solid black and black/red

Can anyone tell me which goes where? I would be very grateful!

Also, I am preparing to sell them... if anyone has suggestions on best place to post. I don’t relish the thought of shipping them, they are VERY heavy and shipping cost would probably be prohibitive.

Thank you in advance, Peter
peterturoff
erik_squires
16,245 posts
 
Just looked at that crossover.  A 2 Ohm coil in parallel with the 4 ohm?  I can only imagine what the curve on that looks like.

Classic Infinity. :)
erik_squires
16,245 posts
 
So I just simulated this using XSim and resistors for the drivers.

If the impedance magnitude is correct, and driver resonance is a good reason why it would not be, the two woofers in parallel without the switch being thrown go down to about 1.5 Ohms at 42 Hz.

Hopefully this is actually where the driver resonance is, because otherwise it's horrific.  The few actual impedance curves I've seen of Infinity speakers from the era have been horrible too.
peterturoff OP
1 posts
 
Thank you!
More to discover