I find that the auto EQ works fine for all frequencies, if "fine" means perfectly flat response 2Hz -20KHz (in my system). I have a multichannel system, and two DEQ2496, and I do the front left and right and the surrounds each channel separately. Because my room is not symetrical, and one speaker system (MG1.6 and a subwoofer) is in a corner the EQ curves are quite different. I have a single channel parametric for the center front, and, by comparison it is a big pain you know where. I do run the white noise up to 85 dB or so when I do the auto EQ. After the auto EQ is done, and while the noise is still on you can turn down the volume and see if the frequency response changes. Mine does not.
Behringer DEQ2496 HELP
After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
- ...
- 136 posts total
- 136 posts total