British audio engineer, Gilbert Briggs, who founded Wharfdale in the late 30's wrote a number of interesting books on "loudspeaker" design. He installed speakers into bricked-in corners in a room - must have had a very supportive partner. My takeaway from one of his books was the use of bonded dissimilar materials so that their natural resonances would tend to cancel each other out. Taking his advice, I glued 12" square sheets of mosaic tiles, then grouted them, on the inside surfaces of my cabinets - enjoyed listening to those speakers for 50 years. Probably for the same reason Wharfdale sold loudspeakers with sand-filled voids in their walls in the 50s.
Concrete Audio Speakers...Speaker Enclosures made out of Concrete ?..
Could concrete speaker enclosures give us the most realistic sound ?
https://www.concrete-audio.com//en/#lautsprecher
Not connected with this company in any way
https://www.concrete-audio.com//en/#lautsprecher
Not connected with this company in any way
- ...
- 71 posts total
kenjit1,013 posts08-12-2020 10:37am How will the speaker shaped by kenjit sound?If I had a speaker company my speakers would have to be perfect. No ringing or resonances. Just pure music. Me, the dog, the rabbit, and the GOAT, all of our heads, cocked sideways. The chickens didn't though. BOING! NO RESONANCES, either... hum! At least some ok.. Something gotta come out of the front of the speakers, just saying K! ;-) Regards |
Kenjit is wrong concrete. Does not resonate the issiue is weight and ability to ship without damage Jim thiel and paul hales had speakers with cconcreate front baffles Both made great speakers Just got in cast ironand graphite speakers from jern they sound unbelievable http://jernspeakers.com/ 0 cabinet resonanance they sound like 10k speakrs yet cost about 4k Compleately disssapear speed and articulación are. Off the charts when used with a good sub willl embarass a lot of extremely expensive speakers Dave and troy Audio intellect Nj Jern dealers |
I had some Essence speakers in the 80's. Each driver, 5 per side, were mounted to concrete, then finished on the outside with medite, then walnut, except the bottom, woofer. Each speaker housing was separate for time alignment and made a nice pyramid. 10k in '82 was a lot of money, but they sounded fantastic. Before and after speakers were Snell Type A and Quad ESLs. |
audiotroy2,546 posts08-16-2020 12:26am Kenjit is wrong concrete. Does not resonate the issiue is weight and ability to ship without damage <<<<<<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>>>> My oh my, I don’t think he is, but I do think you are... CONCRETE is REAL bad.... GROUT mixes on the other hand.. quit good.. Concrete is WAY to heavy because of the rock type and size. Grout on the other hand, less than half the weight (depending on the fluff) and can have a very DEAD signature.. Again NO ONE uses, granite. You cannot use granite. They use synthetic granite, ATH @ Corian... Granite, basite, any igneous rock will ring... It has a very low concentration of silica. The baffle mix has to have a high porosity (bubbles in the mix, but no voids) Igneous rock, is a NO NO.. Some naturally occurring sedimentary, looks good and can work, but has no strength.. Metamorphic, changes under great heat, pressure and TIME. It’s out... just like Igneous, way to dence, very difficult to work with, without some pretty fancy tools.. The weight, out of sight!! the heaviest of all, ay? Try cutting 3-20 driver holes, praying the whole time, hole # 10 won’t have a problem, much less # 20.. Now lets add an OOPS or two in the mix... :-) Regards |
- 71 posts total