The secret to a great amplifier...

Wow, this thread went to a black hole in a hurry!

Several things we need to be aware of:

- If you have looked inside a fuse (like the glass fuses), you will see a VERY thin wire. Say a 1 amp fuse. The internal wire is extremely small, something like 26awg or 28awg (not entirely sure). If this is for a preamp, would you ever put on a power cable smaller than 18awg? (that’s stock, and I don’t think they make them smaller). No, you would upgrade to something like 14awg or even 12awg -- so that there is less current restriction. All A/C has to go through this tiny wire, even if it’s less than 1" long.

- The wire in the fuse has electrical resonance as well. Different upgraded fuses will sometimes do things to combat this resonance. The same thing happens inside electrolytic capacitors (during charge/discharge). The material/filler used in capacitors has a definite affect on electrical resonance and sound quality. Poor resistance to electrical resonance in caps will result is harsh sound that lacks solidness.

- People who say that the fuse and power cords are not in the signal path are not entirely correct. The actual waveform signal that starts at the source is never the actual signal that makes it to the amp. For anyone who doesn’t realize this, the basic idea of a transistor or op amp circuit is to "regenerate" the incoming signal. It never truly "passes through". There is always a resistor that the signal passes through and then a opamp/transistor gain circuit. Well, the gain circuit uses voltage/current from the A/C power supply to re-create or "add to" the output voltage for the signal. The power cord and fuse has a definite impact to the quality of this power supply voltage/current.

- Since A/C power is used to create/add-to this signal, the type of power cord or fuse will definitely affect the "flavor" of the sound. Just like comparing gold-plated connector to rhodium plated. Comparing silver wire to copper wire, etc.

- There are things that our ears are hearing which we cannot measure for at our current level of technology. Granted, electrical engineers will "nay say" this, but ask yourself this: What can we measure today that we couldn’t measure 10 years ago? 20 years? 35 years? (when they were making tube based electronics).