2. cables
  3. 158956-46

Audio envy - dang!

I usually post on AG when I have an issue or concern, so I’m happy for once it’s to praise a new product, in this case Audio Envy’s IC. 

I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.

I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s

Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.

The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”

And that’s just what I did.
last_lemming
lalitk's avatar
lalitk
5,614 posts
 
@last_lemming,

It appears you’ve ordered the SP9’s with ‘bare’ copper sleeves terminations (same as I did). No doubt, they require bit of care while making connection with binding posts. If you’re concerned with possible short which shouldn’t be the case if they are tightly secured. But in any case for your piece of mind, you may use something like ETI bullet plugs (I just uploaded a pic on my system page for your reference). It’s the last pic, the ETI Link banana plugs are the best I’ve found and they seems to be tailor made for AE wires with copper sleeves. They hold the wire very securely.

https://systems.audiogon.com/systems/8046

https://www.vhaudio.com/eti-link-banana.html
maxima95
298 posts
 
The picture on the web site shows them as a "U" shaped, apparently soldered to the wires and covered with heat shrink.

Do yours look like this?
https://i1.wp.com/audioenvy.com/wp-content/uploads/2016/08/IMG_4243.jpg?fit=1920%2C1280&ssl=1
jayctoy's avatar
jayctoy
4,225 posts
 
After maybe 15 hrs of play and using cardas sweep burn in , my phono Cable it sounds more quiet, one thing I notice is the natural sound of voice and instruments, I use to get crosstalk hum from my Denafrips Dac Ares, now it’s gone , including radio station frequency pick up.This is truly an amazing phono Cable.
last_lemming OP
639 posts
 
@maxima95 

No mine do not look like that. I don’t think there is a pic on the site of mine but I may be mistaken. 
last_lemming OP
639 posts
 
@lalitk 

Why do you say tailor made?  Do you know the gage of each wire, or your best guess?
More to discover