There is video, I forget where i saw it, that demonstrates when you have adequately set anti-skate. It depicts the stylus in the dead wax, run-out groove, moving towards the label slowly. If it moves to quickly, you have too little anti-skate. I just follow the instructions provided with both cartridge and turntable and set and forget it.
A new way of adjusting anti skate!
I was looking at the Wallyskater, a $250 or so contraption used to set anti skate. https://www.wallyanalog.com/wallyskater It is reputedly the most accurate way to set anti skate. Talking about fiddly.
The appropriate figure is 9 to 11 percent of VTF. So if you are tracking at 2 grams you want 0.2 grams of anti skate.
My Charisma tracks at 2.4 grams so I should set the anti skate for 0.24 grams..................................Bright light!.
I readjusted the Syrinx PU3 to zero so that it was floating horizontally. I set up a digital VTF gauge on it's side at the edge of the platter so that the finger lift would be in the cross hairs, activated the anti skate and was easily able to adjust it to 0.24 grams. I started at 0.18 grams and just added a little more. Whatever you measure the anti skate from it has to be at the same radius as the stylus. If you do not have a finger lift at the right location you can tack a toothpick to the head shell and measure from that. As long as you have the whole affair balanced at zero you will be fine. Added cost $0.00 as long as you have a digital VTF gauge.
I would not buy stock in Wallyskater.
The appropriate figure is 9 to 11 percent of VTF. So if you are tracking at 2 grams you want 0.2 grams of anti skate.
My Charisma tracks at 2.4 grams so I should set the anti skate for 0.24 grams..................................Bright light!.
I readjusted the Syrinx PU3 to zero so that it was floating horizontally. I set up a digital VTF gauge on it's side at the edge of the platter so that the finger lift would be in the cross hairs, activated the anti skate and was easily able to adjust it to 0.24 grams. I started at 0.18 grams and just added a little more. Whatever you measure the anti skate from it has to be at the same radius as the stylus. If you do not have a finger lift at the right location you can tack a toothpick to the head shell and measure from that. As long as you have the whole affair balanced at zero you will be fine. Added cost $0.00 as long as you have a digital VTF gauge.
I would not buy stock in Wallyskater.
- ...
- 98 posts total
- 98 posts total