2. digital
  3. 161950-76845

BlueSound Stinks(!), anyone?

I am looking for your help.  We recently switched from Sonos to BlueSound to get higher streaming rates.  So far we have had consistent problems and issues(!!).  Specifically, about 50% of the time my and my wife's BlueSound app does not recognize the Node 2i's.  When I delete the app, reinstall it and reconnect the Nodes, we again have the same problems at least 50% of the time.  It is simply a joke of a product and I find we are not alone.  I have tried just about everything.

Also, when I go online to get help, I find that I am not alone and there is a tsunami of negative (to the degree of very hostile) comments about BlueSound and for the most part it is the same issue.  I have tried just about everything and I am about to simply trash/sell mine and go back to Sonos.  If I do go back to Sonos, I will also leave a stream of bad comments on every forum I can since going back to Sonos will represent a big financial loss to me simply because Bluesound is an irresponsible/deceptive company at my expense.

Alternatively, I just want it to reliably work.  Do you you have and advice and/or guidance to get Bluesound to reliably work?  Is there a better alternative to to get higher bit rates thank Bluesound?

Thank you in advance for your help.  Dave


butterman
butterman OP
10 posts
 
I will give BlueSound a few more chances although Sonos worked so well it set the bar vary high and of course, Sonos is less expensive.  

Does anyone know if the new S2 Sonos software will allow high res rates?  I was just reading up on it and it seems to set the stage to allow for higher rates.  That would work for me and if I struggle anymore with Bluesound I could at least get higher rates back at Sonos....and no frustration.  Thanks, 

mgrif104
357 posts
 
It can be frustrating. 

If at all possible, connect your Node via Ethernet as opposed to WiFi.  My problems went away completely when I did.  You can get a bridge or set up a mesh network and plug into the Ethernet ports on one of your waypoints.  

Frankly, that’s an easier solution than replacing the router (which is sometimes called for when there are WiFi stability issues).  And, you’ll get the benefit of better WiFi coverage in your home, too.

Good luck.
rocray's avatar
rocray
1,448 posts
 
I had issues like the OP about a year ago. I replaced/upgraded my WiFi router and the issues magically disappeared. 
Post removed 
bkeske's avatar
bkeske
5,597 posts
 
Interesting thread. I have been contemplating a Node 2i myself, and doing research on it and looking into the Apple app, it seems most folks on the App Store have a negative view of the app operation, or lack thereof. Which surprised me as so many like the streamer here.

Perhaps I’ll just stick to my inexpensive Dayton Audio little streaming box/access point. It seems to work well, and I don’t need to use the app at all unless streaming from my sever hard drive. It also sounds better than hooking up my MacBook Pro to my DAC via USB.
More to discover