2. cables
  3. 158956-46

Audio envy - dang!

I usually post on AG when I have an issue or concern, so I’m happy for once it’s to praise a new product, in this case Audio Envy’s IC. 

I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.

I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s

Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.

The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”

And that’s just what I did.
last_lemming
jackd
1,068 posts
 
It wouldn’t be grounded. If you tell Cap what your doing he will point you to the right cable.
lalitk's avatar
lalitk
5,537 posts
 
@cd45123,

I do not think the two cords are sonically different, they both possess exceptional tonality and transparency.

Explaining ‘what would happen’ is like taking a shot in the dark since I am not familiar with your audio system. Using a ungrounded power cord on a integrated is like using a cheater plug. Typically you do that to reduce hum from ground loops of connected equipment. Using a ungrounded PC on a integrated which draws the most current may become susceptible to RFI interference not to mention potential safety hazard (electric shock or fire).

I would consult with Captain at Audio Envy before you use 2p on a integrated. Sorry, I have not compared the sp6 vs sp9. His cables are so affordable, I would just get the latest SP9.
cd45123
195 posts
 
Ok appreciate it. Yeah, might as well buy both, they’re quite the deal. Went with the SP-9s earlier and they stack up well against stuff that’s much more from some big brands.
madavid0
214 posts
 
The great deal of overwhelmed positivity over these cables is a red flag to me. Use of extreme hyperbole over cables is concerning.

The fact is I discovered Audio Envy a few years ago in the market floor of an audio show, I forget which...possibly AXPONA? The low price of these modest, lightweight cables lured me over. I chatted with the owner for a bit. Thought what the hell, sounds like it would be a great phono interconnect and bought a set. When I put them in the system I don’t recall them wowing me, blowing my socks off, being a revelation, game-changer, "transparent" (as if there is any other kind) or anything of the like. I didn’t think they were bad. Since they seemed like a cheap, safe bet I got another set and a power cable too.

This thread has inspired me to critically test these cables. If this is social media marketing campaign they’re going to be sorry for drawing my attention. But if the hype is true than I’ll be added to the choir.
sojourn98
11 posts
 
I've ordered 5 IC, 2 SC and 3PC after auditioning one AE Studio Prestige IC, Just the one IC connected to my 110db compression driver into waveguides elicited an easily heard improvement,  especially transparency initially..

More to discover