2. analog
  3. 162685-132884

TUBE BIAS, socket to me!

BIAS: (I'm starting from zero understanding) 

I have never measured/adjusted bias in the 3 tube amps, 3 tube receivers, and 2 tube preamps I have acquired over 47 years. I just switched my current Cayin from 6550's to KT88's. Adjust bias? Adjusters inside, scary electrocution warnings. I could pay someone else to do it, i.e. Steve at VAS 1 hr away in NJ, soooo, 

What really counts? (personally I don't care about either heat or life, but would like to understand)

Heat?
Life?
Output stays Matched when adjusted?
Acoustic Performance?
_________?

Over the years, fronts off, bottoms off, I hose em down with contact cleaner/lubricant, compressed air, all controls and switchers, any adjusters, swish full spin back and forth. Kill any spiders, look for, replace the rare burnt resistor. 
Then leave any adjusters (whatever they are) in the middle position, button it back up.

Two tube testers, my big hickock always agrees with small portable one, test strength, shorts, matched strength old and newly purchased. Large collection of NOS, used. Often used test essentially same strength as new ones.

When they go, it's usually a short.
elliottbnewcombjr
elliottbnewcombjr OP
5,529 posts
 

twoleftears

Thanks, that is the factory manual which I have, no mention of bias at all.

I found a discussion from audiogon member plangco, says ,4; he uses .35 for longer life and warmer sound.

It is his "the voltages can be lethal" that gives me late life cowardice.

That, and the very old but unforgettable memory of being kicked on my assss by a tv I had just unplugged. I replaced the cheap internal speaker with a better external one. That's when I realized, there has always been the potential of better sound out of TV signals.
elliottbnewcombjr OP
5,529 posts
 
millercarbon

thanks for providing that understanding, big help just knowing 'why' bias exists.

Is it fair to say, if it sounds great, don't mess with it, or why bother as some suggest?

As for 'right or wrong', 'better or worse' how do you know unless you have a problem, or a problem/change presents itself?

Up to now, those same 47 years, my friends and I: any and all of my tube stuff has always been preferable to SS (darn good SS) with 'middle of the adjuster' settings.
elliottbnewcombjr OP
5,529 posts
 
jjss49

I should have answered you earlier,

A88T, original version (they don't call it mk1).

It has internal bias adjusters, and it is the only version that has 4/8/16 ohm taps for my 16 ohm speakers.

Newer versions eliminated the 16 ohm tap, and added convenient and safe external bias meter and adjuster.
elliottbnewcombjr OP
5,529 posts
 

lewm

thanks for taking the time to respond with all that information.

Sonically, what are your experiences?
elliottbnewcombjr OP
5,529 posts
 
bdp24

thanks for the reference, I'll search for his name, his recommendations.

Any personal experiences?
More to discover