RME ADI-2 direct to amp

I've run my ADI-2 directly into my poweramp (Rogue ST100) and it sounded good, albeit a bit drier and less full than when running the ADI-2 through my preamp (Rogue RP7).  I suppose these are preamp colorations (or perhaps there was an impedance issue with directly driving the poweramp?) but the DAC into the preamp sounded better to my ears.

Kinda what I'm thinking. I am running class D amp so I think my tubey preamp fleshes things out a bit. Ill give it a shot anyway if I purchase. 
Currently using DAC inside Node 2 so I'm expecting a descent jump in performance with something like the RME. 

You should be happy mofojo.
Please report back after acclimation

gakerty
I’ve run my ADI-2 directly into my poweramp (Rogue ST100) and it sounded good, albeit a bit drier and less full

Definitely can’t be a impedance issue, your Rouge is 200kohm input and only needs 1v in to for full power out, no problem going direct

I think dryer tighter is a good thing, maybe just need a re-tune speaker position a little closer to the back wall maybe, system/room/interconnects.

Also did you stay with the 4ohm taps on the ST100? Because the 8ohm now maybe fuller richer and far more powerful also.

Cheers George

I've been using my RME ADI 2 Pro as a preamp direct to power amp (tube, soild state, and class D) for a few years, as well as a headphone amp, without issue.