RME ADI-2 direct to amp

I get it that it will work. When I tried it 10 years ago with my Wyred it worked as well, just sounded hard albeit more detailed. I can infer from milked's post he liked it since he has used it that way for several years. 

Things that should be technically superior do not always sound that way to my ears. 

The RME is really an amazing component for the money.....  I sold my NAD M51 to a guy to use in a second system....what was his main system DAC?  A RME ADI 2 FS DAC.....

When I tried it 10 years ago with my Wyred it worked as well, just sounded hard albeit more detailed.

My mate has a WFS and it too is hard when doing PCM Redbook compared to my discrete R2R MSB, which has even more detail and dynamics. I think it more the WFS dac being exposed when direct.

Cheers George

Which MSB do you have George? Do you run amp direct with it? 

mofojo OP Which MSB do you have George? Do you run amp direct with it?

The MSB Discrete R2R Ladder Dac that I do run direct, because it’s remote control digital domain volume is a few clicks off full up so (no bit stripping) at the level I listen to.

If I have far more efficient speakers or amps with higher sensitivity in the system,   so the volume of the MSB then is far lower, and then probably ( bit stripping), then I would use my passive in between dac and amp, set it’s level, so then the MSB is back up near full again and use it’s remote volume control again.

Cheers George