Gotta say, the XA25 is an excellent choice and shoots much higher than it is “rated”. Pass very conservatively rated the amp with a .01% THD wattage measurement, at the typical 1% THD measurement it’s actually over three times higher. It really is an excellent amp. Very high bias Class A operation, runs hot, but not a blast furnace. Best thing? For a Class A amp it’s tiny. But a power house.
High Output Preamp for First Watt SIT-3?
I'm new to the audiophile world and recently purchased a First Watt SIT-3 with Magnepan .7s. I have a Mytek Brooklyn Bridge for streaming, though I prefer to play vinyl with my Mofi Ultradeck. The Mytek serves as the phono stage (69dB gain for MM?), and I don't use a preamp; the Brooklyn is connected directly to the First Watt.
I understand that the SIT-3 is only 11.5 dB of gain, and that's extremely low compared to most amps. I like most everything about the system except for the fact that I have the Mytek maxed out volume-wise many days. Certain LPs are cut quieter, and I wish I had more power. There are times streaming where the Maggies aren't getting to their sweet spot. I realize the Maggies are a lower sensitivity speaker.
What should I look for in a preamp to fully drive the SIT-3? Eventually, I'd like to replace the phono stage instead of relying on the Brooklyn. Is there a tube preamp featuring a phono stage with sufficient output to drive my amp in the $4k range? Otherwise, I'm eyeing the Modwright PH 9.0 and a linestage preamp, realizing that this will probably be costlier. I'm looking for a warm sound, not analytical but engaging.
Any help is greatly appreciated. I'm a working musician with a basic understanding of related electronics but little experience in this world.
I understand that the SIT-3 is only 11.5 dB of gain, and that's extremely low compared to most amps. I like most everything about the system except for the fact that I have the Mytek maxed out volume-wise many days. Certain LPs are cut quieter, and I wish I had more power. There are times streaming where the Maggies aren't getting to their sweet spot. I realize the Maggies are a lower sensitivity speaker.
What should I look for in a preamp to fully drive the SIT-3? Eventually, I'd like to replace the phono stage instead of relying on the Brooklyn. Is there a tube preamp featuring a phono stage with sufficient output to drive my amp in the $4k range? Otherwise, I'm eyeing the Modwright PH 9.0 and a linestage preamp, realizing that this will probably be costlier. I'm looking for a warm sound, not analytical but engaging.
Any help is greatly appreciated. I'm a working musician with a basic understanding of related electronics but little experience in this world.
- ...
- 85 posts total
- 85 posts total