2. amps-preamps
  3. 164140-153226

Adcom 555se on a smart strip?

I'm thinking about a used Adcom 555se to power my new Ohm Walsh 4000s as recommended by John and Evan. This amp doesn't have a 12v trigger. My stereo "area" is the living room and the preamp will sit in the built-in cabinets next to the fireplace. I don't really want to put a high powered amp in the cabinet for ventilation reasons, so the basement seems like a good choice (and save space in the cabinets for more LPs). With no 12v trigger to power the amp on/off, I was thinking about having the preamp plugged into the control outlet of a smart power strip, and the amp plugged into one of the switched outlets. This will of course work for powering on, but I'm concerned about powering off. When powering off the preamp which will happen first, will it create a pop sound before the amp gets shut off? 

If this smart strip is a viable way to go in this situation, the used 555se will be a great cost savings. If not, I'll start looking at the Adcom 575se or maybe the Parasound A21+. 

Thanks guys and gals.
keysrawk
erik_squires
16,057 posts
 
You know there are power conditioners with 12V triggers.
oldhvymec
5,101 posts
 
I haven’t herd the new Adcom.
I use to use, the older ones, I still have a "FEW".

I do own a ZPre3 and did own an A21. That was a great amp. Mine was paired with old Mac gear at the time.. Sure worked. Great MB, mids and highs. I sold the A21 and went class D Nord. More of a sideways move.
BUT it gave me monoblocks, I needed at the time.
I kept the Mac and added the Zpre3 for the remote, Dac, volume, and sub control. Just flawless!

I like Parasound. Great gear, great prices. A little techy to work on, though IF they ever need work. 12v trigger the A21 had one.

The off / on with a power strip, volume down wait a couple of seconds, and try it.. SEE if it pops.. Put it in to mute, and power down..

Regard
keysrawk OP
15 posts
 
I guess coming from the pro audio world and being a bit of a n00b with the hi-fi stuff, I'm confused as to how a 12v trigger powers off an amp appropriately. Maybe this doesn't matter as much in hi-fi. I always shut off amps first, then any other equipment. Perhaps the preamp and amp shut off exactly at the same time?

How could a Parasound P6 output trigger turn off the amp first before the P6 itself goes off? Or, for amps that have auto-sensing audio triggers (not 12 volt), they usually remain on for 5 minutes after no signal, then shut off. Does that mean I tell my wife and kids to wait 5 minutes after their done listening to music before shutting off the preamp? You know that isn't going to work.
More to discover