2. analog
  3. 164321-157688

Distortion/too much bass from turntable

Hi I recently acquired a Sony PS-LX7 turntable and everything appears to work fine except I'm getting some distortion. It sounds like it's either too much bass or the sound is too loud and thus distorting.

I'm using a Sony Moving Magnet XL-200 cartridge and a Sony ND-200 stylus. I have it hooked up to a Sony TA-F45 amplifier and have the ground and RCA connections in place correctly. The Cartridge Load switch is set to MM at 180pF.

Incidentally I tried hooking it up to a USB sound card that has specific ground and phono amp specifications and the same thing happens, so I'm assuming the distortion is coming from the turntable itself.

Any suggestions on how to get a clean sound? I have also tried isolating the power plug to reduce/eliminate electrical interference but it doesn't seem to make a difference.

Thanks.
garfycat
garfycat OP
3 posts
 
@simao Thanks. I replaced the stylus already so hopefully I can find a new cartridge that will be compatible!
fuzztone's avatar
fuzztone
5,582 posts
 
Just get a Puffin. Then you can obtain any sound that pleased you.
millercarbon's avatar
millercarbon
12,531 posts
 
garfycat,
Your table has a built-in phono stage. If connected to the phono input of your amp then the turntable must be set to PHONO. https://www.sony.com/electronics/support/audio-components-turntables/ps-lx7/articles/00032249 Otherwise, if the turntable is set to LINE then the signal is going through RIAA equalization and preamplification twice. The result will be way too much bass, and probably distortion too, since the level will be way too high for the phono stage.
noromance's avatar
noromance
9,763 posts
 
A few other thought to those above. Tracking weight too high? VTF. Arm parallel with record? The lid could also be causing acoustic feedback.


oldhvymec
5,101 posts
 
It's old, it's broke, oh my. 

Eeyore
More to discover