2. speakers
  3. 147808-7805

Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

Cube Audio (Poland) designs single drivers and single driver speakers. 

Principals are Grzegorz Rulka and Marek Kostrzyński.

Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page: 

https://www.cubeaudio.eu/cube-audio-nenuphar

Link to 6Moons review by Srajan Ebaen (August 2018):

https://6moons.com/audioreview_articles/cubeaudio2/

----------------------------------------

Parameters (from Cube Audio):

​Power: 40 W

Efficiency: 92 dB

Frequency response: 30Hz - 18kHz ( 6db)*

​Dimensions: 30 x 50 x 105 cm

Weight: 40 Kg


* Frequency response may vary and depends on room size and accompanying electronic equipment.
david_ten
charles1dad's avatar
charles1dad
10,250 posts
 
@vinpic,
Thank you for your reply, I now more clearly understand the passive Icon replacing the Vinnie Rossi active DHT Line stage. The analogy comparing the Bakoon13R and S.I.T.3 is very effective and clarifies their different sonic presentations.

Very interested in your listening impression of the incoming Valvet amplifier. I saw elsewhere on this forum you’ve had the Ypsilon integrated amplifier. You have certainly had/heard your share of really fine quality audio equipment. Sound Kaos? Nice! I look forward to reading more of your posts.
Charles
paullb
130 posts
 
@david_ten, 
Thanks for asking. Yes, pretty much, especially when stephen dunn chimed in and said that his Vinny Rossi integrated sounded even better when he put resistors into lower the damping factor. Still curious about the Bakoon. I have not been able to find a figure on the web for its damping factor, but it's unique Satri circuit could have something to do with it. Seems like low damping factor is a good rule of thumb, though there may always be outliers.

Paul
vinpic
34 posts
 
@stephendunn 
Keen to try your resistor solution for the VR L2iSE.  Can you pls share model of resistor Vinnie recommended, how to install, any precautions etc.  If you could add a photo that would be great.  Thx!
david_ten OP
5,480 posts
 
@paullb   Paul, you are welcome!  Richard( @toetapaudio ) may be able to help out with more information on Bakoon. He is a Bakoon dealer and has the most experience, among those posting here, pairing it with the Cube Audio line.
david_ten OP
5,480 posts
 
@vinpic  If memory serves, I think you are one of the first to post ownership experience with the Nenuphar Monitors in combination with a Cube Audio Sub.

The comparative perspective coming from the standard Nenuphars is really cool and significant, as is your varied experience with some excellent amplifier pairings. I'm looking forward to the results with your inbound Valvet amp.

Thanks for sharing your setup and what's been working and preferred by you. Great information for those following this thread. - David.
More to discover