2. speakers
  3. 147808-7805

Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

Cube Audio (Poland) designs single drivers and single driver speakers. 

Principals are Grzegorz Rulka and Marek Kostrzyński.

Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page: 

https://www.cubeaudio.eu/cube-audio-nenuphar

Link to 6Moons review by Srajan Ebaen (August 2018):

https://6moons.com/audioreview_articles/cubeaudio2/

----------------------------------------

Parameters (from Cube Audio):

​Power: 40 W

Efficiency: 92 dB

Frequency response: 30Hz - 18kHz ( 6db)*

​Dimensions: 30 x 50 x 105 cm

Weight: 40 Kg


* Frequency response may vary and depends on room size and accompanying electronic equipment.
david_ten
david_ten OP
5,480 posts
 
@vinpic Thanks for the update. Comparing it to the Ypsilon Phaeton says a lot!

Valvet’s AE4s are on my radar to explore / experience a higher watt and solid state pairing for the Nenuphars; and to serve as a ’book end’ in terms of differences from my 2A3 amps.

Looking forward to your updates as you run the E2SEs in.
charles1dad's avatar
charles1dad
10,250 posts
 
@vinpic, 
Agree with David that favorable comparison to the Ypsiplon is high praise. Valvet amplifiers are  consistently well regarded.
Charles 
abd1
157 posts
 
@david_ten how did you install the rear brass bumpers on your Cubes? Did you have to install threaded inserts? Thanks 
david_ten OP
5,480 posts
 
@abd1  I went with the unthreaded version of these:

https://edensoundaudio.com/shop/hemispike-extra-large/

I used commercial / industrial grade double sided adhesive discs.  I have not had any slippage.

The bottom rear cabinet area can be drilled, but it is tricky and there is a chance one may damage/crack the finish.
abd1
157 posts
 
@david_ten So did you just wrap the adhesive discs around the hemisphere threads and insert? I have the hemispheres but haven't installed and still using the stock rubber bumpers. Where did you get the discs? Thanks.
More to discover