Fuse upgrade on Marantz SA-10 & Marantz UD9004

valentinofv OP1 posts03-07-2021 10:09pmraysmtb1 :

I respect your opinion; however, that’s not the answer I was looking for. Thanks anyway.

<<<<<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>>

You may respect it but I don’t.. I’d return the information to the broken record it came from. Fuses and a walkman for the clown...

Yea no more MR. nice guy here.

Add that one to the Eeyore 6 list.

Though one person is half way off, my crap list, I crawled on myself, with some of the CRAP I been reading lately..

The things people think they hear, BUT fuses CAN make a difference.. 

OP do this. Take the fuses you currently have, turn them around one at a time, "IF" you hear a difference, chances are a fuse change will be a nice sonic nuget, if not.. SAVE YOUR MONEY.. A dab of silicone on the glass tube or wrap the fuse with a piece of tape. Use contact enhancer on the tips of the fuse and clean the fuse holder. Add enhancer (just a tiny little bit) with a Q-Tip.

101 "Make my system better for peanuts" Copy rights may apply.. :-)

Respect, I'm gonna' quit sayin' Regards

Respect

Well Mr. heavy mechanic I used to have a Lotta respect for you. Remember those interconnects from China filled with oil that you recommended ....you said they made a nice difference.  I bought a set...not only did they not make a difference all they did was leak that oil all over the floor. Do you know where they are now? In the garbage is where they are! Along with the  $65 I spent on them. I used to think that you were the man now I’m wondering if you’re not just a junk man. I’ve gotten suckered into so much crap in this audio world. If I wasn’t a quadriplegic I’d kick  my self! What a joke all this crap is. 

The fuse is likely mounted on a circuit board very close to the IEC power cord inlet.  You would have to take the cover off and potentially remove other circuit boards that are mounted on top to get to the main A/C power input board.  Since both of these players are high end transports that have some heavy analog boards, I would probably recommend a 2A fuse (it is likely a small 5x20mm fuse, but you would have to examine this to make sure).

raysmtb1 It’s all BS and snake oil

valentinofv OP1 posts

that’s not the answer I was looking for.
I’ve heard you can improve the sound quality significantly when doing it.

And here we go again, 1 post and and a "staunch fuser" already, and to boot not looking for the truth, even though asking for it???? which was given by Ray.

BTW wrong forum also, "Mics-Audio" is the forum for this thread, as there’s NO "PRO" tech-talk available on this subject and never will be, not buy anyone with technical cred anyway, just by snake oil fusers.

The fuse is likely mounted on a circuit board very close to the IEC power cord inlet. You would have to take the cover off and potentially remove other circuit boards that are mounted on top to get to the main A/C power input board. Since both of these players are high end transports that have some heavy analog boards, I would probably recommend a 2A fuse (it is likely a small 5x20mm fuse, but you would have to examine this to make sure).

Very dangerous for someone to play around with, that can't find this them for themselves.
I hope some of you fusers have insurance for telling them to do go ahead and play around with lethal mains potential components inside equipment!!!!.