S/PDIF-how different than an IC?

+1 @kijanki.

Blue Jeans Cable sells an SPDIF cable that seems to be well engineered and for 3-foot length is $19 plus freight. I have a couple of their SPDIF cables that I use when I need one. I had them made with yellow cabling, so I don’t mix them up with ordinary interconnects.

Like others have said, you can technically use a standard IC for a digital S/PDIF connection.  It will work because they are both just a wire that is connected using RCA plugs.  However, the IC is likely not going to perform as well because of the shielding and impedance requirements of the S/PDIF specification. 

The specificaion states a recommended use of BNC connector due to the 75 ohm design.  Most manufacturers just use RCA because this was a trend started a long time ago.  The problem is that RCA has an actual impedance of about 30-35 ohms.  This means it is more likely to have signal reflection problems.  This occurs when the digital pulse hits the receiver on the DAC side and actually produces a pulse reflection (like a sound wave reflected off a wall).  That reflection travels back down the cable to the source and causes distortion and inaccuracies on additional transmitted pulses.  The audible result is loss of high frequency resolution or other audio inaccuracies. 

Also, I always recommend 2 meter cable minimum to reduce reflections, even on BNC cables.

I make my own cables. SPDIF cables are made with high bandwidth 75 ohm coaxial wire and special RCA plugs with crimp on pins to maintain that bandwidth or BNC connectors.  AES/EBU cables are high bandwidth balance wire with standard XLR connectors. Regular interconnects technically do not have the bandwidth to support the higher frequencies required to pass on dense digital information such as 192/24. Only a single cable is required as both channels are contained in the signal.

Thanks all. The DAC in question (see my OP) is the SW1X III Balanced. I started out with a dedicated S/PDIF that came with BNC's but also came with BNC-RCA adaptors. My Aurender W20 offers both BNC and RCA outs among others. So I used the BNC out from the Aurender. I had to use the adaptor for the DAC since it only has an RCA input. I choose not to ID the cable maker but the cable is highly regarded though modestly priced (under $400) but in this particular application sounded dull and lifeless. 
Then, out of frustration, I pulled a 2M Analysis Plus Silver Apex RCA IC from somewhere else in my system to try. You would never believe that a simple cable swap could make so much difference. It was like the sun came out on a crappy day. Every audio descriptor or so-called attribute came out from hiding and I have been smiling ear to ear for 48 hours since the swap. Now I have ordered a custom made 1.5M S/PDIF using the Silver Apex conductor and construction from Analysis Plus. When I inquired of AP, I was told the IC would approximate but not duplicate the performance of the S/PDIF version and that it would NOT simply be a single run of Silver Apex IC. It cost me just under $800 for the single cable. 
If anyone here is interested, I will report back. Auxinput's input (pun) has me thinking I should have ordered 2M. Oh well.