Installing Dedicated Power Lines -- Need Advice

Circling back to the Decware vs. regenerator issue. Here is what P.S. Audio wrote to me when I asked them about using both: "I don’t agree with the statement from Decware [that Decware's conditioner can be used in addition to a regenerator]. We do not recommend a line conditioner in conjunction with our power regenerators. We do feel that they can limit the power coming in from the wall by using high/low pass filters which do essentially choke the electricity to the regenerator."

So, which is it? Decware's version of what is best or P.S. Audio's? @millercarbon  I'm still curious what you think since you have a lot of experience with power and also recommended the Decware.

@dkidknow - I think the biggest limitation may be that you are likely sharing power, or at least ground, with other units. I've never done a room in a coop or multi-unit building but only in single family houses. The dedicated lines give you some assurance that there are no noise inducing appliances on the same circuit as your hi-fi gear, but they all source back to a panel which feeds other equipment and in turn is tied to a common ground. In one house, I could hear certain lights and appliances despite dedicated lines in a listening room on the third floor of the house, at a remove from the noise inducing appliances. 
I was never too concerned about audiophile branded wire for the dedicated runs or even for the receptacles, going with 10 gauge and the Hubbell hospital grade receptacles I mentioned from Albert Porter. 
Your question about addressing problems at the source would lead me to ask how the power to your unit is wired from the building's utility room-- something you are probably not able to change, but an inspection by a qualified electrician may be informative. I also don't know what code permits you to build in (e.g. an isolation transformer) as opposed to a "black box" that connects to the receptacle. The gent I mentioned in an earlier post in this thread, @jea48, has especially deep knowledge of code and best practices. 

Circling back to the Decware vs. regenerator issue. Here is what P.S. Audio wrote to me when I asked them about using both: "I don’t agree with the statement from Decware [that Decware's conditioner can be used in addition to a regenerator]. We do not recommend a line conditioner in conjunction with our power regenerators. We do feel that they can limit the power coming in from the wall by using high/low pass filters which do essentially choke the electricity to the regenerator."

So, which is it? Decware's version of what is best or P.S. Audio's? @millercarbon  I'm still curious what you think since you have a lot of experience with power and also recommended the Decware.

First time I called a manufacturer asking about something like this was around 1992. Mr Aronov assured me they use only the finest caps and there is nothing to be gained and we will not be responsible when you ruin our fine amp. Went ahead and was shocked how much better it sounded with $5 worth of HEXFRED diodes. Liquid, deep, black, the works.  

Tried the same thing a few more times until I gave up, finally realizing no manufacturer will ever tell you the truth, "We use the cheapest parts we feel we can get away with, and why not, I have a family to feed, and have you seen what a Ferrari costs these days?"  

Hard to argue. But what about power cords, fuses, vibration control? Let me assure you, deja vu all over again.  

Not only manufacturers. When I was new to autocross I went around asking guys what tire pressure they run. It's a club, friendly competition, they will tell me, right? Ha! Don't make me laugh! One guy seriously told me he doesn't know- WHILE HOLDING THE GAUGE TO THE VALVE STEM!

Your homework assignment if you want to be the best audiophile you can be is to watch every episode of House, MD. There you will learn the most important lesson: here let me get you off to a good start- 
https://youtu.be/HgXpvzt7Qg8?t=105

@millercarbon I love House! Great show. And I understand why manufacturers mislead or lie. But if a regenerator’s very design obviates the need for a conditioner -- which is a statement of fact (either true or false) -- then its being uttered by a manufacturer doesn’t change its truth value. To argue it does is ad hominem and doesn’t answer my question.

😳
Serves me right for embellishing the story, you missed the main point: in spite of what the manufacturer told me I went ahead and found out for myself. Most people are so scared and submissive it takes a lot to get them out of the feelings of helplessness our culture has so deeply beat into them. The point of the stories and House is not to say the manufacturer is lying in this specific instance. He is, but that is not the point. The point is to get you to do your own due diligence, to think, and to figure it out for yourself.

PSAudio is full of it. But I only know this on the basis of knowledge and experience far beyond anything I could ever post here. Even then guess what? Everyone lies! I just do it a lot less than most. But if instead of trusting the manufacturer you turn around and trust me just as blindly, well then I have yet again failed to get my point across.