Does tube testers tell how much life is left for tubes?

An approximation of tube life can be found from the cathode emissions, which I think some testers can provide.

When the cathode electron emission drops way low the tube is at the end of its life.

Tubes can test good right up to the end time of failure.

RIght, the testers can tell you whether or not the tube is OK. They can not tell you how much time is left on the tube until the tube starts to measure poorly which means the tube is at deaths door. I use tubes until they fail and in my experience they sound just fine until they do fail. 

I always keep a full set in reserve. If one tube fails I replace the whole lot unless that particular tube was obviously defective. I keep my phono stage on in standby. The tubes, 6922's last an average of 6 years.

different tubes age in different ways

6dj8 6922 types, in my experience, get noisy with tube ’rush’ or hiss, and microphonic long before they quit entirely - not sure why this happens in the physics occurring inside the tube as time passes -- these will test fine on the tester for gm but then plug em into the linestage or phono stage and they are unlistenable

depending on the application, that change defines their effective ’use-ability’

other tubes may age differently... typical power tubes usually get dull in sound (lose treble detail imaging etc etc) as they get into last 30-40% of their lives

In the end, we usually are alerted to the possibility that a tube or tubes are failing by the fact that the our system sounds "off", not as good as usual.  Only then are we motivated to test tubes.  At that point, if any tubes measure low in transconductance, I ditch them in favor of new.  That nearly always results in restoration of SQ.  I own an ancient Hickok 533A, which I can use to test small signal dual triodes only, to include octal based tubes like the 6SN7 and 6SL7, and it is not much good for testing modern very high transconductance triodes like the 5687 group or the 6DJ8 group, because of its current limitations.  I just shoot for an approximation of "good" with those.  The 533A is no good at all for testing the monster 7241 triodes in my power amplifiers, and for that I just go by listening and then measuring the tubes in situ.  The 7241 is a US milspec power triode developed for use in radar installations.  It can easily run on up to 1A plate current, although I do not stress them that much.