Boy, Oh Boy! Towshend!

Seems you have options. Having a trial period to listen to products - that's been my suggestion all along.

@millercarbon @rixthetrick 

Well, apparently Townsend isolation corners WILL isolate every single component in my equipment rack. Got it from the source!
I asked John at Townshend: "As far as the isolation corners isolating my equipment rack down to 3Hz, what about the individual components. Will they also be isolated down to 3Hz? As I cannot fit isolation pods under most of the components."John: Yes everything on top of the rack is Isolated

Me: Just to clarify, when you said "Yes everything on top of the rack is Isolated" did you mean, all 9 components within each rack shelf of the Sound Anchors rack or just the components(turntables and tonearm etc) on the top of the rack. John: Once your rack is floating on our Seismic Corners everything that is on the rack is Isolated down to 3hz.------------
So what do you think MC? Pretty economical way to isolate 9 components vs 36 isolation pods!
The isolation corners and 4 speaker bars would do the trick. John also recommended speaker bars on my sub. However my sub is 18" wide?
But I'm thinking, getting 4 Nobsound springs(if they can handle 140 pounds) would be a much more economical way to proceed if they would not affect the Townshend isolation. 4 isolation pods would cost less than half as much as speaker bars...Thoughts?
The only issue here is getting to the right rear corner of my equipment rack. Unless I pull the rack  way out away from the back and side wall(see imgur dot com slash a slash FEI0zPQ to see the rack and walls) and successfully! slide the corner back in place over the tile and grout lines, no way can the rack corner be lifted to get the spike into the small isolation corner spike hole. Even if I follow John's advice about removing all heavy components and center speaker first...It's still 300+ pounds!

Well first, John is right- as far as he goes. Yes if the whole rack is on Pods then everything on the rack is isolated. But remember it is not just isolation from the environment, it is also isolating each component from everything else. The difference is each component generates its own internal vibrations. Very important.  

So even with the rack isolated there will still be improvement isolating each individual component. 

This is not an either/or thing. Building a system is all and/and/and. And. And andandand....  Neverending and's. Usually what happens is we run out of money way before we run out of and's to do. The rack is your only option since there is no room, and it is probably better than doing only whatever few components you can. Again: do what you can. Don't sweat the small stuff! 

Nobsound can handle way more than 140lbs. It is more like 50lbs per unit, or 200lbs altogether. At 140lbs you probably only need 5 or 6 of the 7 springs.  

In terms of cost-effectiveness, the main difference is Townshend is superbly damped while Nobsound isn't damped at all. Because of this the Pods, Bars or whatever will have a lot better tone, way better truth of timbre, and improved slam compared to Nobsound. All these are much more noticeable in midrange and treble where most of this information comes from and where our hearing is most sensitive. Way down low in the bass is always harder to hear.    

That is why I added springs first where I did, and waited until later to move from springs to Pods under my subs. Will be migrating from springs to Pods under my subs next so we will know soon enough. Meantime I would say if you have to cut corners anywhere use springs under the subs and Pods, etc everywhere else.  

As for getting them under the rack, a picture's worth a thousand words. Meantime I have four choice words for you: leverage is your friend.

As I previously mentioned, I would call Peter at Symposium Acoustics and see wheat he thinks. He talks about “best bang for the buck” all the time. He might recommend roller blocks, platforms, or some combo, and if he can’t fit, he won’t force it.

@millercarbon
I understand and thank you. So now there are several considerations about the rack isolation. And what is most important. For me, it's my 2 turntables, and their tonearms and cartridges and my tube phono drive(which there is room for pods). I don't think my Vertere turntable motor drive that supplies the 33 and 45 rpm signal to the turntable motor needs additional isolation. Or at least expensive isolation? Maybe springs? The t.t.'s are up on top and have their own suspension systems. They may be ok...No room for anything with my Classe Processor unfortunately. Only an 1/8" or so.... For my DVD/CD player, only about 1.5" or so room. Currently with an air bladder platform with a leak undeneath. So not functional. Might as well remove it.

As far as the Nobsound's, I was only considering those for the Sub. If I only use the sub for home theater(or low volume bass add on for 2 channel), would the springs be satisfactory enough?My Mezzo's bass is really good. But maybe with proper isolation, the sub might be worth using fuller in 2 channel. I don't know. I never turn it up more than 5% or so.

Leverage will work(a dolly) under the accessible front corners and left rear corner pretty easily. Getting leverage to the right rear corner will be super tough. I wonder if I can get a car jack to fit. There's about 1.5" of space below the base bars....I only need to raise each corner about 3/4".

So the isolation corners will isolate my rack components from my speakers and maybe my sub. Fingers crossed that my turntables well designed suspension systems mitigate their own vibrations.

After the isolation corners, then it's a question of where to place Pods. Or maybe Nobsound springs? They are 1.49"(I cannot find information on how tall the Pods are) so they will just barely fit under my Marantz DVD/CD player. Are they worth putting under my Node 2i streamer box? Or Rowland center speaker mono amp? Or P.I. Audio UberBuss power conditioner? Or Dish network satellite box? Or my Rowland Model 12 monoblock amps?

I just pumped up the Townshend Seismic Sink that was under my Basis turntable and it has not sunk. Yet. Let's see tomorrow.

My system currently sounds so great now.

With isolation- I feel hot and cold(can't explain).... Yeah down in my soul yeah(can't explain).