testing a crossover

Hi Guys,thankyou so much for all your help,but i still dont see a solution to this problem,in my opinion there is shorts in both xos,please see below-

             LEFT SPEAKER                                  /
 RIGHT SPEAKER
                speaker terminals with everything connected on both speakers

     MID/HIGH        0.0 ohms                             /
    MID/HIGH    0.0 ohms
       BASS           7.9 Ohms                             /
       bass          6.8Ohms

                                      DRIVER TEST DISCONNECTED FROM X OVER
          TWEETER 8 OHMS                                 /
    7.9 OHMS
              MID 6.3 OHMS                                   /
         6.2 OHMS
             BASS  6.1 OHMS                                /
       6.0 OHMS

     CONTINUITY TEST ON X-OVER WITH DRIVERS REMOVED USING DIODE FUNCTION
                                             between positive and
negative on x over
         HF                  000.2 {dead short}
         /       000.2 {dead short}
         MF                  000.5
              /       000.5
         LF                     OL.
                /        OL.
MID HIGH INPUT IP     OL.                                 /
                OL.
   BASS INPUT            OL.                                 /
                   OL.
                                                  OL. BEING NO CONTINUITY

                               TEST TESTED AT/ON X-OVER SPEAKERS CONNECTED OHMS

         HF 0.0002 OHMS                                      /
              0.002 OHMS
         MF 0.0001 OHMS                                      /
               2.0 OHMS
         LF   6.4 OHMS                                          /
                   6.3 OHMS
ive also now removed one lead from all the caps on one xo,and tested them with a cap meter,all caps are the correct uf ,within spec,can anyone tell me where to go from here,
thankyou again for all your kind help.regards Mark

i am using internal xo,which came with the speakers
all tests done with power amps disconnected.
the problem{ going pop{broken}only happens when the speakers are driven in bi-amp config,and its the amp which is driving the high/mid drivers that blows up .
when using only one amp,in bi-wire config,everything works,all be it the sounds quality is slightly off,but i would have thought that to be ok,that why i bi-amp,for better sound quality.
to add to this,i changed out the xo caps for better ones two years ago,and after fitting them ,i tested the input speaker terminals for the correct ohms reading and all was good,but something has changed.
regards Mark

i would also upload some photos, but as this is my first ever use on this site,im not sure how to do this, any help appreciated,
mark

I would like to help as I'm an avid bi/tri-amper. I would guess you've checked the cables and wiring to the amp and speakers? I don't know anything about the crossovers in the speakers, is it possible to draw a schematic or shoot some photos? I use an active crossover at the inputs of my amps to limit the frequency range to each driver, tri-amping. Nothing but wire between the voice coils and amp outputs. This configuration virtually eliminates intermodulation distortion, which is most offensive to the ears. I've been bi-amping for 44 years and tri-amping for 41 years. Might be as simple as bad caps in the crossovers you are using. If you would like, I could send a PM to you with my email and you could send me a schematic or photos of your speaker crossovers. I'm positive we can get to the problem without much effort. 

i would also upload some photos, but as this is my first ever use on this site,im not sure how to do this

Go to Virtual Systems page, use the "Create System" to upload photos.

https://systems.audiogon.com/