Power cord choice?

cleeds3,918 posts07-25-2021 8:57amturnbowm

An example would be a series-mode surge suppression/conditioner that doesn’t use Power Factor (energy reserve) technology. The result would be reduced dynamics and bass impact due to dynamic current-starving of a power amp.

"That’s nonsense."

Furman uses the term "Power Factor" while Audioquest calls it "Power Correction." In both cases, energy storage is provided by large capacitors that can satisfy the dynamic current demands of power amps. Without the caps, the very component (inductor) that limits the surge current also limits the dynamic current that is available to the amp. Simply put, an inductor opposes changes in current flow and that presents a problem for power amps.

turnbowm

Furman uses the term "Power Factor" while Audioquest calls it "Power Correction."

I think you’re spending a little too much time reading manufacturer’s brochures and not enough time understanding what’s going on. Audioquest can use whatever marketing lingo it likes, but "Power Factor" is the accepted and proper term for describing the relative phase between voltage and current, which in residential environments is typically 1 or very, very close to it.

... energy storage is provided by large capacitors that can satisfy the dynamic current demands of power amps ...

Yes, that’s what capacitors do.

Without the caps, the very component (inductor) that limits the surge current also limits the dynamic current that is available to the amp.

If you think all power conditioners rely on inductors that compromise PF, you’re mistaken. You're also mistaken if you isolate PF as the most critical factor in delivering full power.

The Puritan 156 was my 2nd choice. It is a very good unit. But I passed on it because it had (9000A) surge suppression chokes or the like and instead had an electrician install a Seimens FS140 with 140,000A protection at the breaker box.

I would look into PI Audio's UberBuss. It has independant outlets, a power factor correction of 1 and a non metal exterior box to eliminate Eddy currents and more. Each outlet handles 20A+( to Puritan's 15A). The UberBuss can actually output 40A+ spikes....It cost less than the Puritan and IMHO is a better power conditioner.

Get a Triode Wire Labs High Power Digital Ameican power cable with the $ you saved and you'll be in the best situation.

Look into the UberBuss before you buy.

cleeds3,919 posts07-25-2021 10:05am"If you think all power conditioners rely on inductors that compromise PF, you’re mistaken. You're also mistaken if you isolate PF as the most critical factor in delivering full power."

You seem to be making some very broad assumptions which are simply wrong. I'm well acquainted with series-mode and parallel-mode surge suppressors/conditioners and their design differences.

You seem to have an argumentative nature. Is everything all right?

@cleeds   I agree that no one test can be held up as universally true.  However, that doesn't explain why there is no apparent difference in sound when the new high-end cable is put into service?  How can the improvement in sound not be obvious to everyone who listens?  I live with the belief that every upgrade I've made to my system has provided a "small" improvement, while being hard/impossible to discern on it's own, the accumulated impact of many changes is much better sound.  I have simply become accustomed to the results and so don't remember how lacking it was previously.  This stops me from opening a vein when I think of the $$$$$ I've spent chasing the dream.  Hmmmm, new Mercedes or a set of Legacy V speakers?  ha ha ha