^^^^^^ Good Post ^^^^^^
If practicable silver solder in place
If practicable silver solder in place
DIY cables question
@scOrpi043 There are some very talented dyi cable members on the site, e.g. wig, grannyring, williewonka , etc check out the FORUM thread below to find them. I assume that they would be willing to give you guidance that you need on your own build. And, based upon my experience with one of those member’s cables, there are very good sounding and manufacturer competitive dyi cables aside from the sole one mentioned above https://forum.audiogon.com/discussions/duelund-conversion-to-diy-helix-geometry-cabling |
Making a good proper pair of cables for audio are not easy. You can make some cheap DIY cables and they can sound decent. I've done that before using Cat5/or Goertz foils. But they won't be as good as good as a well engineered pair of cables. It also depends on the overall level of your system. If you have some budget system, DIY cables are probably alright. But if you have some high-end system, then DIY probably are not good enough. The audio cable industry is filled with imitators so you have to be careful with that too. I would stick with some well known brands. There are too many bad actors that give the industry a bad name. |
I'm no expert but if your solder joint is gray or looks like a bubble gum blob you may want to resolder. Solder joint should be shiny or mirror like. A solder sucker is your friend. I've always found when you tin stranded wire it should be totally soldered through out the wire but should be able to see each strand of wire, place a small amount of solder in cup heat cup up, place tinned wire in cup let it become one still able to see each strand of wire, pull on wire for durability and your done. Ive made my own wire for ten years or more some can sound very nice but never have been able to compete with high end wire. I've used stranded, solid silver, solid and stranded copper, magnets, vibration control but it's very tricky to make wire that can compete with $1000 and up cable. Power cables seem to be the easiest to make sound good. Use nice quality connectors good wire and some clamps and vibration control and they can sound pretty good for what they are. For speaker wire wire I use bare wire. In one system I have speaker wire hard wired to amp and outboard crossover. No bulky big copper binding post. |