2. speakers
  3. 168839-20253

A loose connection can be madenning

I put together my desktop speakers kind of in a hurry. Low on money and needing to move out of my apartment in the very immediate future. They are 2-way speakers with traditional crossovers. Now one of them has gone mostly silent and troubleshooting it with the right tools reminds me of how hard it must be fore those who don’t have them.

I’m using bot a digital multi-meter (DMM) and a speaker impedance analyzer, DATS V2 from Dayton/Parts Express. I think they are now in V3. Step one, measure the DC resistance. 20 Ohms. Oy. OK. Take off the front panel and the woofer connection is loose. Fix it, reassemble. 9 Ohms. Still too high. Run DATS. Sure enough, the impedance curve from 2 kHz down is around 20 Ohms. Something else is wrong. Disassemble and go through all of the connections in the bass crossover one at a time.

For anyone who has to do any trouble shooting inside a speaker, let alone replace parts, DATS is indispensable. Cheap around $130 far cheaper than some power cables!

Can’t say the process is fun right now though.
erik_squires
fuzztone's avatar
fuzztone
5,517 posts
 
Main right woofer was crackling like the mag gap was rubbing. 
Then it went silent.  Pulled it out and the spring loaded lead grabber was lose.  Tightened it up with some thread lock.  All good. 

Fun.
erik_squires OP
16,004 posts
 
Disassembled the speaker.  The drivers and crossovers are out and on my workbench.  Tested the woofer circuit alone.  It works fine, measures exactly as it should.  The woofer's resonant peak is there, followed by a flat impedance until 1 kHz where the impedance rises, at it should, since this is a low pass filter.

What does this tell me?  The connection problem was undoubtedly in the mating of the crossover to the banana plugs which felt pretty loose, honestly.  I'm remaking them.
erik_squires OP
16,004 posts
 
Everything has been rewired.  Man, I really was in a hurry, since there are wires in here I don't even know what they were for now. :-)

Tested the impedance curve again from the banana plugs, but front baffle is still not on.  Curve looks perfect, except missing the obligatory 2nd resonant hump in the bass for a bass reflex section.  That will come when I put the baffle back on.  For now I have the correct and expected impedance curve. Now I have to hope nothing comes apart when I put it all in the cabinet.
More to discover