2. tech-talk
  3. 169140-5759

Electrolytic capacitor replacement

I want to swap out a couple of electrolytic caps with higher quality caps, also electrolytic. The ones I am looking at are all physically bigger than the ones I am replacing, and consequently the leads don’t fit the board. The rubicon’s I want to bin are have a diameter of around 3/4’ and the caps I’m considering are between 1’ and 2’. The big issue I have is the lead spacing.

I’m considering using a spacer between the pc board and the cap giving enough room for the leads to bend enough to fit the board. I have space on the board to fit a larger cap, but not enough to mount the caps on their side. The caps new will need to sit “upright”.

Id appreciate it if somebody has figured an eloquent solution for this.

Thanks
pauly
pauly OP
1,012 posts
 
Got you. I am interested in using film for both better sound and reliability. I’m going to try and see if I can squeeze Mundorf Tubecaps in. 
The 30uFs are rectangular and if I can superglue them against the sidewall I’ll get them enough of them in. Maybe. 
pauly OP
1,012 posts
 
@grannyring


Ok, short of taking a hacksaw to my chassis, I cannot use Tubecaps. I think I’m going to have to settle the Mundorf Mlytic. Do recommend bypassing them? 

I want to use the 50+50uF three prong. The ODAM is a little too expensive for bypassing - I need to replace 4 caps per amp. I’m a little under spec, the current electrolytic are 56uF. What would you recommend?
grannyring's avatar
grannyring
6,541 posts
 
You can measure what’s in there and see what value they really are. Electrolytics can vary up to 20% depending on spec.  You can ask Sonic Craft to match the caps as close to 55uf as possible. 
Yes, use bypass caps for sure. You can use a cap like Audience Auricap XO, Clarity CSA, and Jantzen Superior Z. Make sure they are high enough voltage for your circuit. 1-3 uf or so is fine. 
bigkidz
3,406 posts
 
I generally use Nichicon capacitors in power supplies, etc.  Clarity if I have to.  Then Mundorf.

I prefer V-Caps to the other capacitors.  I generally do not find a need to use by-pass capacitors.  Some people use them all the time.  I have not found that they are a big improvement over other changes.
Happy Listening.
itsjustme
682 posts
 
Elegant would be more eloquent. Ditch the board. Hardwire direct. That's what I did. See the last couple pics on my system page.

:-) correct on both.  But wait, there's more.
I often drill holes in the existing PCB that match the leads, and use copper solid wire to hard wire it.  use adhesive ot hold the cap firmly in place.

Now, in what what are the new one's "superior".  If not larger, you are barking up the wrong tree. On a relative basis 'lytics suck -- all of them. Use the world's cheapest film cap in parallel and it will still b 10X better.  I suspect one is already there. if not shame on them.  I means really shame on them.
More to discover