REMINDER: tighten up your loose screws


REMINDER, tighten up all loose screws around the drivers. Just Do It. All of them.
Sit back and enjoy your “new system”.

85% of screws on my speakers needed 1/8 to pass 1/4 turn to snug firmly and guess this… all screws on my woofers needed 1 full turn. Some was actually needed 2 turns. Anyways, improvement was a jaw dropping.
Credit reminder to Rick from High Fidelity Cables
128x128nasaman
Yes!

My 15" woofers weigh 37 lbs each, plus the mid and tweeter horns. 

And both the front and rear panels are removable with air tight gaskets. 

every 6 months I remove the back, check and tighten anything that might be loose, most often not, but occasionally yes.

I don't have removable grilles, so once a year I take the woofers off the back of the front panel so I can inspect their cone and surround (pleated cloth not foam). Rare from 1958, so I keep a spare woofer and spare rebuild kit ready to go downstairs.

I inherited a very cool antique long screwdriver, it helps me reach and I get to think of Poppy every time I use it.
I had a similar experience with my speaker binding posts between my outboard XOs and the speakers
My new brass screws set for the drivers from Amazon is arriving today. Excite to see if there will be any improvement from what already is from tighten them up.
My new brass screws set for the drivers from Amazon is arriving today. Excite to see if there will be any improvement from what already is.
I own MAGICO Q3s/M3s no screws they are inside the speaker and never need tightening.