30 to 50 watts seems to be all I desire

Low power class A SS amps here as well. Small room’s and lower listening volumes.  

It is the gain on both the preamp and power amp that effects the use of the volume control.

I have a tubed pre, with adj. gain, combined with a 27db of gain on my amp. The pre`s gain set to 16 db= too loud; volume at 9:00, the pre`s gain set to 8 db= too loud; vol.  at 12:00.

I also have a low gain integrated w/ passive preamp section with a gain of 20 db. Unfortunately for me, I had to turn the vol. knob all the way to 2:00 for same level of volume.

@audiodwebe 

Caveat:  Listening to mainly Jazz at volumes less than 85db, normally.

This explans in large part your outcome and the fact that you listen in a modest size room. Quality of your amplifier has more bearing than the quantity of watts. Your scenario makes perfect sense to me.

As others have pointed out, the limited volume control usage range is a reflection of excess gain in an audio system and is not due to too much amplifier power. The higher the sensitivity of your speakers or amplifiers the less preamplifier gain is needed. If your digital source or phono cartridge is high voltage output,  the less gain you require. 

Charles 

I’m down from 255wpc with a Hafler DH-500 to 17 wpc from Dyna/VTA 70 with KT66 in triode mode. Plenty loud for me with average efficiency speakers in a 24x24 ft room, and sounds amazing.

The AVERAGE watts even on inefficient speakers playing loud is only in the low single digits. Even an avreage twenty watts would either drive you out of the room or else make youd deaf. Power is used for very, very short term transients which can be 20 to 30 dB(20 Db is a multiplier of 100). These transients are very short and good amps recover from the overload very quickly. But even good amps clip these transients and weaken the fidelity. If you want the best sound as my old friend George Bischoff(Melos amps, 200 and 400 watts triode) said - a good big un will beat a good little un every time.