Replicant 100 stylus


My ''general statement'' that styli are produced by either Ogura or Namiki

may need correction.

Some friends of my ''discovered'' that Replicant (Ortofon), Decca and

''Expert stylus'' are the same. As is/was the case with Gyger and

Van den Hul. Van den Hul designed Gyeger I, II and S (?) but

Gyger produced them. This was obviously kept secret for commercial

reasons.

My assertion is that Expert stylus (Paratrace) provide them to the

other mentioned.

Is anybody capable to check this information?

 

128x128nandric

OK @nandric I am receiving loud and clear,  I don't need a new thread to commence, I will not offer any further input to this thread unless I discover if  ' Expert stylus (Paratrace) provide them to the other mentioned '.

In the opening Post beyond the claim that a correction may be needed, there are references to Five Brands and Five differing Stylus Form/Models from those Brands, that does not steer one towards a specific subject matter about a Specific Stylus Form, the Thread has evolved into a multi faceted 'pardon the pun' range of discussion.

     

As I explained in my introduction 3 persons looking true microscope

were not able to see any difference between Paratrace, Replicant

and stylus in London Decca. This imply that ''someone'' must produced

this stylus. ''Someone'' is existential quantifier because ''lt'' assume

existence of some object or entity. There this name Pegasus which

assumes existence of an flying  horse. We somehow know that this

animal does not exists. Logical  reading of this quantifier is that the

statement which entail this expression is true if at least  one object

satisfy condition ''some''. More than one is also welcome.

You stated : ''I am open to be corrected''. 

Really? 

Well which question are you trying to answer? 

''We'' also have similar problem with dover. He is not only ''high level

humorist '' but also enjoy teasing his co-member nandric. .To my

self invitation to N.Zealand he offered to me one half glass of wine.

And to my opinion about ''retips'' I got his advice to ask my

retiper to turn the same stylus ''left for right'' because only right

side is worn out because I don't use anti-skate. 

So it may be possible that his place were Replicant are produced is

not really Ireland? 

In an ideal world, if only one side of the Tip was seen to be with excessive wear, a 'retip' service would not be required, turning the Cart' 180 Degrees on the Headshell mounting would be a simple fix requiring a much lesser skill set.