Can Music Reference MR9 drive Tannoy DMT 215 II


The Tannoy monitor DMT 215 needs 150 wpc to 500 wpc to drive it. I only have a Music Reference RM9 which is only 100 wpc. Will it ok to drive this monitor without causing amplifier clipping? Please advice! Thanks
kinhoang
I am just having them on the floor vertical and bases to bottom. Preamp I' used Supratek. Sound so good that I have to put all other speakers away for now. Only one problem is that there is a soft hum on both sides. Not to sure why but never had that hum on other speakers. Is there anything wrong with the Tannoy or the MR 9? Yours must be so quite Jburidan? How many inches from floor to the monitor? I am trying to build my own.
:)
Found another issue is that the bass kind off too boomy, which putting mid range and vocal back. All I can think of it could cause by monitors sit flat on floor. So will try to sit them on the footer that off floor about 8 inches may help.
@ Clio9 and Charles1dad, thanks!
I
Very high sensitivity speakers (like yours) will easily reproduce ANY noise present in your system. Tube amps and preamps generally have some hiss present and occasionally some hum too. You might try lifting the ground with a cheater plug on the amp just as an experiment but it sounds like the hum is low in level and normal given your mix of equipment. If it's not too intrusive I wouldn't worry about it. The other speakers you were using were not likely as efficient as your current set which is why you didn't hear the hum.
This is a question that I am surprised is even being asked, the answer being so obvious and such....

Shakey
I would be surprised if the RM-9 were the source of the noise but as previously mentioned the sensitivity of your speakers will let more noise through. An easy test is to get a set of shorting plugs and put them on the inputs of the amp. Then turn it on and listen for any noise at the speaker. If no noise or the noise you currently hear is reduced then the problem is elsewhere. Another thing, if you are using unshielded cables on the amp due to where the inputs st so close to the transformers they may be picking up some noise. Roger recommends shielded cables and a bit extra length that allows you to move the cables away from the transformers.
The op posted this because 150 - 500 watts is Tannoys recommendation. Those speakers are amazing. They will take anything and everything you can throw at them.