Ted ?
Synergistic Orange and purple fuses popping
Synergistic Orange and purple fuses popping
I recently upgraded all my gear with the new Synergistic orange and purple fuses (15 in all) What a difference! My Cary SLP-05 preamp with 8 Vintage Tungsten 6SN7 tubes is having problems with the Orange and Purple Synergistic fuses in the power supply. For some reason when I turn on the preamp amp after warming up the powersupply unit, the 2 power supply fuses pop. So far Synergistic has been gracious and replaced them twice now. I increased the 2 large slow blow fuses from 1amp to 2amps after asking Cary audio what I should try. I also spoke with Synergistic and they agreed their fuses are sensitive but all the stock fuses I ever used have worked flawlessly. Any body out there with any similar problems and maybe a solution? Any upgraded hi-fi fuses that may be less prone to popping? I think it may be due to a current rush (tube related) when I go from off to on. Help!
Thanks
- ...
- 60 posts total
I've had 5 different Cary tube products they all used the 560uf filter caps in the power supply. Mine all did the same thing they were all older units too. They would start running hotter and I had to be very careful flipping from standby to on. They would pop a fuses. I'd change the 2 or 4 560uf caps and the problem would go away. They will leak oil too. LOL I thought I had an old Harley the first time one took a dump. Left a puddle of oil. :-) I was using ACME at the time in my Macs, Carys, VTL, Threshold. I was given SR to try. I wound up paying for blue and orange fuses. 10 or so.. Regards |
@gregtheis if you’ve already received replacement fuses from the factory and the problem persists, than there’s one of a few issues at play here. As others have stated, Synergistic fuses are built to a very tight tolerance. They don’t blow unless there’s an issue. In this case, are you using a fast blow fuse but should be using a slow blow fuse? If so, that’s the problem (I see that you specified slow blow so this is not the issue). Otherwise, as Old Heavy Mech stated, you likely have one or more dried out capacitors and so a massive surge at start up. If this is the case, you are also burning through tubes faster than you should. It’s not a big deal to change out caps in a tube circuit, and one big bonus, you’ll get better sound as well as longer lasting tubes when you do. Lastly if none of these suggestions sound palatable to you, we will make certain you get a full refund through your dealer.
Yours and music, Ted Denney III Lead Designer/CEO Synergistic Research Inc. |
This is result of inrush current, I had the same issue with my Coincident 845 SET amp and former Cary push pull. I went up a couple values both times, no more failures. My take is as long as fuses are blowing they are doing job intended to do.
Perhaps they are undervalued to whats stated on fuse. If they are blowing on startup, they'll also blow if equipment suffers some other failure. |
- 60 posts total